Search Results

An optimizer tool in PC-Crash is designed to minimize reconstruction time and error by automatically varying a selected number of impact parameters, comparing the resulting simulation for each combination of parameters with the actual incident. ...Twenty staged collisions were reconstructed with the optimizer tool in PC-Crash. These staged collisions had been previously reconstructed with a combination of manual linear momentum calculations combined with the trajectory model in an earlier version of PC-Crash. ...These staged collisions had been previously reconstructed with a combination of manual linear momentum calculations combined with the trajectory model in an earlier version of PC-Crash. Differences between the reconstruction simulations and the actual collisions, and methods for minimizing reconstruction errors, are discussed.

HVE 1 and PC-Crash 2 have been the subject of numerous SAE papers. Both programs have been offered to reconstructionists for the purpose of analyzing vehicle accidents and presenting the resulting motions in 3D graphical form.

During recent years the accident simulation program PCCRASH was developed, which allows to simulate the vehicles movement before, during and after the impact. ...Within SAE 1999-01-0444 a new coupling interface of PC-CRASH and the software MADYMO, developed by TNO in the Netherlands was published. During last year's publication only few validation cases, mainly related to rear end impacts could be demonstrated. ...One major emphasis was set on the influence of the crash pulse, which cannot be derived in PC-CRASH. In this way the paper demonstrates the possibilities as well as the limitations of the numerical model.

The introduction of this model eliminated prior limitations that PC-Crash had for simulating motorcycle motion. Within PC-Crash, a user-defined path can be established for a motorcycle, and the software will generate motion consistent with the user-defined path (within the limits of friction and stability) and calculate the motorcycle lean (roll) generated by following that path at the prescribed speed, braking, or acceleration levels. ...However, the model again did not utilize counter-steering to generate lean, and so it is unlikely that the steering inputs generated by PC-Crash would match the real-world steering inputs. Still, the PC-Crash single-track driver model will yield results that are typically adequate for a crash reconstruction or visualization. ...This paper validates the single-track vehicle driver model available in PC-Crash simulation software. The model is tested, and its limitations are described. The introduction of this model eliminated prior limitations that PC-Crash had for simulating motorcycle motion.

During recent years the accident simulation program PC-CRASH was developed, which allows simulating the vehicles movement before, during and after the impact. ...The first one serves as an alternative for the optimizer tool and is included in the current version of PC-Crash. It gives reasonable insight in the variation of certain parameters in reasonable calculation time.

Sensor signals are derived using the PC-Crash tool, and characteristic features are identified. Insights derived from these events can aid in development of robust rollover detection algorithms and calibrations.

Reconstruction by PC-Crash was performed for all of the sampled cases. Pre-crash parameters were calculated by a MATLAB code.