Search Results

Far-side occupants are not addressed in current government regulations around the world even though they account for up to 40% of occupant HARM in side impact crashes. Consequently, there are very few crash tests with far-side dummies available to researchers. Sled tests are frequently used to replicate the dynamic conditions of a full-scale crash test in a controlled setting. However, in far-side crashes the complexity of the occupant kinematics is increased by the longer duration of the motion and by the increased rotation of the vehicle. The successful duplication of occupant motion in these crashes confirms that a sled test is an effective, cost-efficient means of testing and developing far-side occupant restraints or injury countermeasures.

The debate surrounding roof deformation and occupant injury potential has existed in the automotive community for over 30 years. In analysis of real-world rollovers, assessment of roof deformation and occupant compartment space starts with the post-accident roof position. Dynamic movement of the roof structure during a rollover sequence is generally acknowledged but quantification of the dynamic roof displacement has been limited. Previous assessment of dynamic roof deformation has been generally limited to review of the video footage from staged rollover events. Rollover testing for the evaluation of injury potential has typically been studied utilizing instrumented test dummies, on-board and off-board cameras, and measurements of residual crush. This study introduces an analysis of previously undocumented real-time data to be considered in the evaluation of the roof structure's dynamic behavior during a rollover event.

A 3-2-2-2 array of linear accelerometers and a combination of a triaxial linear accelerometer and a triaxial angular rate sensor were mounted into a Hybrid III 50th percentile male ATD head-form and compared in a variety of short- and long-duration events. An appropriate low-pass filter cutoff frequency for differentiating the angular rate sensor data into angular accelerations was found by using a residual analysis to find individual cutoff frequencies for the three center of mass (COM) linear accelerometer channels and the three angular rate sensor channels and taking the arithmetic mean of the six cutoffs. The angular rate sensors provide more accurate rotational rates than integrated angular accelerations calculated from arrays of linear accelerometers and are less cumbersome, especially for events lasting longer than 200 ms.

Seatback strength and injury potential in moderate to high-speed rear-end collisions were investigated in a series of 12 HYGE sled tests. The test methodology included the use of instrumented Hybrid-III anthropomorphic test devices (ATDs). Four tests employed a 95th percentile male ATD ballasted to a total weight of 300 lbs and subjected to approximate 15 mph Delta-V impacts. The remaining tests employed an unmodified 50th percentile male ATD with impacts of approximately 25 mph Delta-V, and three ATD positions, including two "out of position" postures corresponding to leaning forward ("forward" position), and leaning forward and inboard ("radio" position). Seats from three different vehicles were tested, representing a range of strength values. Upper neck values for N were less than 1.0 in all cases. Lower neck N values sometimes exceeded 1.0 with the 50th percentile male ATD out of position, and these values did not trend with seatback strength.