Search Results

Engine and flow reactor experiments were conducted to determine the impact of biodiesel relative to ultra-low-sulfur diesel (ULSD) on inhibition of the selective catalytic reduction (SCR) reaction over an Fe-zeolite catalyst. Fe-zeolite SCR catalysts have the ability to adsorb and store unburned hydrocarbons (HC) at temperatures below 300°C. These stored HCs inhibit or block NOx-ammonia reaction sites at low temperatures. Although biodiesel is not a hydrocarbon, similar effects are anticipated for unburned biodiesel and its organic combustion products. Flow reactor experiments indicate that in the absence of exposure to HC or B100, NOx conversion begins at between 100° and 200°C. When exposure to unburned fuel occurs at higher temperatures (250°-400°C), the catalyst is able to adsorb a greater mass of biodiesel than of ULSD. Experiments show that when the catalyst is masked with ULSD, NOx conversion is inhibited until it is heated to 400°C.

In the development of HC traps (HCT) for reducing vehicle cold start hydrocarbon (HC)/nitrogen oxide (NOx) emissions, zeolite-based adsorbent materials were studied as key components for the capture and release of the main gasoline-type HC/NOx species in the vehicle exhaust gas. Typical zeolite materials capture and release certain HC and NOx species at low temperatures (<200°C), which is lower than the light-off temperature of a typical three-way catalyst (TWC) (≥250°C). Therefore, a zeolite alone is not effective in enhancing cold start HC/NOx emission control. We have found that a small amount of Pd (<0.5 wt%) dispersed in the zeolite (i.e., BEA) can significantly increase the conversion efficiency of certain HC/NOx species by increasing their release temperature. Pd was also found to modify the adsorption process from pure physisorption to chemisorption and may have played a role in the transformation of the adsorbed HCs to higher molecular weight species.

Lean NOx Traps are used to treat the NOx emissions from lean-burn engines by storing the NOx under lean conditions and reducing the NOx during periodic rich excursions. However, sulfur poisons the adsorption sites of the traps. The sulfur can be removed from the NOx trap by operating rich at high temperatures for several minutes. This results in the release of some SO2 but also large quantities of H2S, which is a source of customer dissatisfaction that must be reduced or eliminated. This paper describes the use of a nickel-containing catalyst and air/fuel control to maximize the release of SO2 and minimize the emissions of H2S during the desulfation of a lean NOx trap. We present laboratory and vehicle data with a nickel-containing catalyst located downstream of a lean NOx trap during desulfations of the trap. The nickel effectively reduced the emissions of H2S during the desulfation while improving the robustness to fluctuations in the air/fuel control.