Search Results

Crankshaft is one of the critical components of an engine (5C: cylinder head, connecting rod, crankshaft, camshaft and cylinder block). It is subjected to repetitive and dynamic loads due to cyclic operation of an engine and inertia forces. Due to uneven mass distribution, failure zones occur near fillets and holes in journal locations during operation of the engine. Hence, this topic was chosen because of increasing interest in higher payloads, lower weight, higher efficiency and shorter load cycles in crankshaft equipment. Calculation of Crankshaft strength consists initially in determining the nominal alternating bending and nominal alternating torsional stresses, which multiplied by the appropriate SCF (Stress Concentration Factor), result in an equivalent alternating stress. This equivalent alternating stress is then compared with the fatigue strength of the selected crankshaft material. This comparison will show whether or not the crankshaft concerned is dimensioned adequately.

Assessment of cooling performance in the design stage of vehicle allows a reduction in the number of needed prototypes and reduces the overall design cycle time. Frontend cooling and thermal management play an essential role in the early stages of commercial vehicle design. Sufficient airflow needs to be available for adequate cooling of the under-hood components. The amount of air mass flow depends on the under-hood geometry details, positioning and size of the grilles, fan operation and the positioning of the other components. Thermal performance depends on the selection of heat exchanger. This paper describes the effects of several design actions on engine cooling performance of a commercial vehicle with the help of Computational Fluid Dynamics (CFD) simulation tool Fluent™. Front of vehicle design is captured in detailed FE model, considering front bumper, grille, cabin, cargo and surrounding under-hood and underbody components.

Advanced Non-linear topology optimization methods have been addressed as the most promising techniques for light weight and performance design of Powertrain structures. The theoretical achievements are obtained both mechanically and mathematically. Nowadays, the great challenge lies in solving more complicated engineering design problems with multidisciplinary objectives or complex structural systems. The purpose of this paper is to provide a forum to present new developments in structural Non-linear topology optimization. The advantage of the proposed method is that structural optimization on irregular design domains can be carried out easily. Furthermore, this method integrates the stress analysis and the boundary evolution within the framework of finite element methods. In this paper, mainly focused on the Commercial Vehicles Powertrain component i.e. Transmission Housing.