Search Results

A production calibrated GTDI 1.6L Ford Fusion was used to demonstrate low HC, CO, NOx, PM (particulate mass), and PN (particulate number) emissions using advanced catalyst technologies with newly developed high porosity substrates and coated GPFs (gasoline particulate filters). The exhaust system consisted of 1.2 liters of TWC (three way catalyst) in the close-coupled position, and 1.6L of coated GPF in the underfloor position. The catalysts were engine-aged on a dynamometer to simulate 150K miles of road aging. Results indicate that ULEV70 emissions can be achieved at ∼$40 of PGM, while also demonstrating PM tailpipe performance far below the proposed California Air Resources Board (CARB) LEV III limit of 1 mg/mi. Along with PM and PN analysis, exhaust system backpressure is also presented with various GPF designs.

The Environmental Protection Agency (EPA) and Department of Transportation's National Highway Traffic Safety Administration (NHTSA) have finalized regulation that will reduce greenhouse gases and increase fuel economy for model year (MY) 2012-2016 light-duty vehicles. This ruling not only includes a CO₂ standard that will require vehicles to achieve fleet average 35 mpg by MY 2016, but will apply a cap on nitrous oxide (N₂O) and methane emissions to 10 and 30 mg/mile, respectively, however CO₂ emission reductions can be exchanged for either N₂O or methane credit. The work outlined investigates the N₂O emissions of a variety of low emission vehicles per the Federal Test Procedure (FTP). Fourier Transform Infrared Spectroscopy (FTIR) was used to measure both bag and modal N₂O emissions. N₂O emissions were less than 1 mg/mile for three SULEV vehicles with 6,400 km-aged catalysts.

The cold start calibration of five different four cylinder Partial Zero Emission Vehicle (PZEV) vehicles are examined. This subset of PZEV vehicles with engine displacements between 2.0 and 2.4L, include direct injection and port fuel injection applications with and without secondary air injection. Calibration parameters such as ignition timing, engine speed, and air-to-fuel ratio of each vehicle are compared. Converter light-off strategies differ drastically during Federal Test Procedure (FTP) cold start with various combinations of high engine idle speeds, aggressive ignition retard, secondary exhaust air injection, and in the case of direct injected (DI) engines, split fuel injections. Emission studies were performed on two of the PZEV vehicles to determine the required platinum group metals (PGM) needed to achieve Super Ultra Low Emission Vehicle (SULEV) SULEV20 and SULEV30 Low Emission Vehicle (LEV) LEV-III emissions requirements.

In-line hydrocarbon (HC) traps are not widely used to reduce HC emissions due to their limited durability, high platinum group metal (PGM) concentrations, complicated processing, and insufficient hydrocarbon (HC) retention temperatures required for efficient conversion by the three-way catalyst component. New trapping materials and system architectures were developed utilizing an engine dynamometer test equipped with dual Fourier Transform Infrared (FTIR) spectrometers for tracking the adsorption and desorption of various HC species during the light-off period. Parallel laboratory reactor studies were conducted which show that the new HC trap formulations extend the traditional adsorption processes (i.e., based on physic-sorption and/or adsorption at acid sites) to chemical reaction mechanisms resulting in oligomerized, dehydro-cyclization, and partial coke formation.