Search Results

Secondary air injection after cold start gives two effects for reduced exhaust emissions: An exothermic reaction at the hot exhaust valves occurs, which increases the temperature of the exhaust gas. It gives sufficient air to the catalyst during the cold start fuel enrichment that is necessary to prevent driveability problems. Handicaps for the wide use of air injection include space constraints, weight and price. An electrical air blower was choosen to best satisfy all these requirements. The development steps are described. The result is a three stage radialblower with extremly high revolutions of about 18000 rpm. The system configuration and the outcome are demonstrated on the new C-Class of Mercedes-Benz. The results show emission reductions higher than 50 %, while also satisfying the development goals of noise, volume, weight and cost requirements.

This paper describes the exhaust emission control system designed for the new Mercedes-Benz sports car generation 300 SL and 500 SL, Remarkable features of the catalytic converters are maximum environmental compatibility, i. e. minimum of emission and noise under all driving conditions. By reduced back-pressure, they also contribute greatly to the well known requirements of a sports car: high performance and high torque over the entire engine-speed-range. Apart from an effective exhaust gas aftertreatment, great efforts were made to prevent the formation of pollutants under all driving conditions. This work is done by intelligent motor management consisting of digital spark control, mechanical-electronic injection, variable valve timing and EGR.

This paper presents the results and conclusions from a conceptual design study for a stratified charging concept. The stratified charging engine has a displacement of 64 cm3 and a four-port design with reed valves at two ports to control the bypass air. During the intake stroke of the engine, bypass air is sucked into the transfer ports to purge the air-fuel mixture present in the ports from the previous stroke back into the crankcase. This fills the transfer ports near the exhaust with pure air at the beginning of the scavenging stroke. During scavenging, the bypass air is ejected in the cylinder, shielding the exhaust against the fresh mixture coming from the ports on the intake side. This allows the hydrocarbon emissions to be reduced by over 40 %. The conceptual design study is based on an analysis of the mixture short-circuiting mechanisms and CFD investigations of the scavenging flow with charge stratification.

When developing effective exhaust emission reduction measures, a better understanding of the complex working cycle in crankcase scavenged two-stroke gasoline engines. However, in a two-stroke gasoline engine detailed measurement and analysis of combustion data requires significantly more effort, when compared to a lower speed four-stroke engine. Particularly demanding are the requirements regarding the high speed (>10,000 rpm) which inevitably goes along with heavy vibrations and high temperatures of the air cooled cylinders. Another major challenge to the measuring equipment is the increased cleaning demand of the optical sensor surface due to the two-stroke gasoline mixture. In addition, the measuring equipment has to be adapted to the small size engines. Therefore, only a fiber optical approach can deliver insight into the cylinder for analyzing the combustion performance.

The quality of mixture formation and the combustion process is of significant importance for reducing the hydrocarbon emissions of small two stroke engines. The scope of this work was to investigate the mixture conditions after the exhaust closes and after the end of combustion depending on various engine operating points. For this experimental investigation a Gas Sampling Valve (GSV) was combined with a flame ionisation detector (FID) and a CO2-analyser. Using this technique, it was possible to measure the hydrocarbon concentration after end of combustion. Furthermore the local residual gas concentration after exhaust closes was determined. To allow for a comparison of the experimental results with calculations with CFD codes, in cylinder pressure measurement and exhaust gas measurements are done additionally.