Search Results

The integration of the exhaust manifold in the engine cylinder head has received considerable attention in recent years for automotive gasoline engines, due to the proven benefits in: engine weight diminution, cost saving, reduced power enrichment, quicker engine and aftertreatment warm-up, improved packaging and simplification of the turbocharger installation. This design practice is still largely unknown in diesel engines because of the greater difficulties, caused by the more complex cylinder head layout, and the expected lower benefits, due to the absence of high-load enrichment. However, the need for improved engine thermomanagement and a quicker catalytic converter warm-up in efficient Euro 6 diesel engines is posing new challenges that an integrated exhaust manifold architecture could effectively address. A recently developed General Motors 1.6L Euro 6 diesel engine has been modified so that the intake and exhaust manifolds are integrated in the cylinder head.

The present paper illustrates an investigation about the potentialities of injection rate shaping coupled with an after injection. A pilot shot can either be absent or present before the rate-shaped boot injection. The experimental tests have been performed on a partial PCCI Euro 5 diesel engine endowed with direct-acting piezoelectric injectors. Starting from optimized triple pilot-main-after injection strategies, boot injection was implemented by maintaining the direct-acting piezo injector needle open at part lift. The results of two steady state working conditions have been presented in terms of engine-out emissions, combustion noise and brake specific fuel consumption. In addition, in-cylinder analyses of the pressure, heat-release rate, temperature and emissions have been evaluated. Considering the in-cylinder pressure traces and the heat release rate curves, the injection rate shaping proved to influence combustion in the absence of a pilot injection to a great extent.

In this paper, the potential of new generation piezo-driven indirect acting injectors on high feature diesel engine performance and emissions was assessed by combining experimental tests (carried out at both hydraulic and engine test beds) with the diagnostics of combustion and emissions. This latter was performed by means of a refined multizone combustion diagnostic tool previously developed at Politecnico di Torino. More in detail, a complete hydraulic characterization of the injection system has been carried out and injector performance, in terms of robustness and repeatability of the injection process, has been also evaluated. Injectors were then installed on 4-cylinder 2.0L Diesel engine and tests were performed in seven key-points, which were specifically selected so as to reproduce the engine operations over NEDC in terms of emissions and fuel consumption.

Temperature variations due to compressibility effects of the liquid fuel were evaluated, for the first time in high-pressure injection system simulation, by employing the energy conservation equation, in addition to the mass-continuity and momentum-balance equations, as well as the constitutive state equation of the liquid. To that end, the physical properties (bulk elasticity modulus, thermal expansivity, kinematic viscosity) of the fluid were used as analytic functions of pressure and temperature obtained by interpolating carefully determined experimental data. Consistent with negligible thermal effects of heat transfer and viscous power losses involved in the flow process, the equation of energy was reduced to a state relation among the fluid thermodynamic properties, leading to a barotropic flow model.

The paper presents the main results of a study on the simulation of energy efficient management of on-board electric and thermal systems for a medium-size passenger vehicle featuring a parallel-hybrid diesel powertrain with a high-voltage belt alternator starter. A set of advanced technologies has been considered on the basis of very aggressive fuel economy targets: base-engine downsizing and friction reduction, combustion optimization, active thermal management, enhanced aftertreatment and downspeeding. Mild-hybridization has also been added with the goal of supporting the downsized/downspeeded engine performance, performing energy recuperation during coasting phases and enabling smooth stop/start and acceleration. The simulation has implemented a dynamic response to the required velocity and manual gear shift profiles in order to reproduce real-driver behavior and has actuated an automatic power split between the Internal Combustion Engine (ICE) and the Electric Machine (EM).