Instantaneous On-Engine Turbine Efficiency for an SI Engine in the Closed Waste Gate Region for 2 Different Turbochargers 2006-01-3389
1D engine simulations of turbocharged engines are difficult to perform with good accuracy. Calculations of turbine performance are based on performance maps. These are measured under steady flow conditions using air at moderate temperatures, not very representative of the very hot and pulsating gas flow the on-engine turbine is exposed to. To improve the predictivity of today's 1D engine calculations or the limiting factors of the turbocharger itself, it is most important to gain deeper understanding of how the turbine behaves under on-engine conditions.
The objective of this paper is to compare calculated instantaneous on-engine turbine efficiency based on measurements with results from using steady-flow efficiency performance maps. The work is performed using two different turbochargers at two operating points with closed waste gate.
It is shown that the turbine efficiency characteristic derived from measurements and that from using steady-flow efficiency performance maps describe a quite different behavior of the turbine. The on-engine turbine efficiency has systematically shown to be asymmetric over an exhaust pulse. It is considerably higher during the “downhill side” of the pulse, a phenomenon not captured by the 1D quasi steady calculations.
An error estimation is made for the measurement-based efficiency. The cumulative error results from individual measurement errors of its constituent parameters. The efficiency uncertainty is most governed and very sensitive to the measurement error of the turbine shaft speed. The pressure before and after the turbine are also important to measure correctly.
Citation: Rehnberg, U., Ångström, H., and Olofsson, U., "Instantaneous On-Engine Turbine Efficiency for an SI Engine in the Closed Waste Gate Region for 2 Different Turbochargers," SAE Technical Paper 2006-01-3389, 2006, https://doi.org/10.4271/2006-01-3389. Download Citation