Development of Engine Control Using the In-Cylinder Pressure Signal in a High Speed Direct Injection Diesel Engine

Seongeun Yu; Han Ho Song; Kyoungdoug Min; Hoimyung Choi; Sunghwan Cho; Kyoungchan Han

doi:10.4271/2011-01-1418

Emissions regulations are becoming more severe, and they remain a principal issue for vehicle manufacturers. Many engine subsystems and control technologies have been introduced to meet the demands of these regulations. For diesel engines, combustion control is one of the most effective approaches to reducing not only engine exhaust emissions but also cylinder-by-cylinder variation. However, the high cost of the pressure sensor and the complex engine head design for the extra equipment are stressful for the manufacturers.

In this paper, a cylinder-pressure-based engine control logic is introduced for a multi-cylinder high speed direct injection (HSDI) diesel engine. The time for 50% of the mass fraction to burn (MFB50) and the IMEP are valuable for identifying combustion status. These two in-cylinder quantities are measured and applied to the engine control logic. Fuel injection timing is controlled to adjust the operating MFB50 to the target MFB50 with PID control logic, and fuel injection quantity is controlled to adjust the measured IMEP to the desired IMEP. The control logic is demonstrated at steady-state and transient conditions and applied to an NEDC mode test.

Standards

SAE Mobilus®

Publications

News

Events

Professional Development

A World in Motion (PreK-12)

Participate with SAE

SAE Membership

Donate

Development of Engine Control Using the In-Cylinder Pressure Signal in a High Speed Direct Injection Diesel Engine 2011-01-1418

SAE MOBILUS