U.S. Army Investigation of Diesel Exhaust Emissions Using JP-8 Fuels with Varying Sulfur Content 961981
Comparative emission measurements were made in two dynamometer-based diesel engines using protocol specified by the U.S. Environmental Protection Agency (EPA) and the California Air Resources Board (CARB). A single JP-8 fuel with a sulfur level of 0.06 weight percent (wt%) was adjusted to sulfur levels of 0.11 and 0.26 wt%. The emission characteristics of the three fuels were compared to the 1994 EPA certification low-sulfur diesel fuel (sulfur level equal to 0.035 wt%) in the Detroit Diesel Corporation (DDC) 1991 prototype Series 60 diesel engine and in the General Motors (GM) 6.2L diesel engine. Comparisons were made using the hot-start transient portion of the heavy-duty diesel engine Federal Test Procedure.
Results from the Army study show that the gaseous emissions for the DDC Series 60 engine using kerosene-based JP-8 fuel are equivalent to values obtained with the 0.035 wt% sulfur EPA certification diesel fuel. Particulate matter response indicates that an approximate sulfur level of 0.21 wt% in kerosene-type JP-8 fuel would be equivalent to the 0.035 wt% sulfur reference fuel. Similarly, the regulated gaseous emissions for the GM 6.2L engine using JP-8 fuel are equivalent to the values obtained with the 0.035 wt% sulfur EPA reference fuel. All sulfur levels of kerosene-type JP-8 fuel up to the 0.30 wt% MIL-T-83133 specification maximum would be equivalent to a 0.035 wt% sulfur EPA reference fuel for particulate matter response.