New Developments in Lean NOx Catalysis for Gasoline Fueled Passenger Cars in Europe 962047
There is an increasing interest in running gasoline fueled passenger cars lean of stoichiometric air to fuel (A/F) ratio to improve fuel economy. These types of engines will operate at lean A/F ratios during cruising at partial load and return to stoichiometric or even rich conditions when more power is required. The challenge for the engine and catalyst manufacturer is to develop a system which will combine the high activity rates of a state-of-the-art three way catalyst (TWC) with the ability to reduce nitrogen oxides (NOx) under excess of oxygen. The target is to achieve the future legislation limits (EURO III/IV) in the European Union. Recent developments in automotive pollution control catalysis have shown that the utilization of NOx adsorption materials is a suitable way for reduction of NOx emissions of gasoline fueled lean burn engines. However, the primary task for the implementation of this technology in the European market will be to improve the high temperature stability and to decrease the susceptibility to sulfur poisoning.
The present paper outlines results of a recent research and development program to achieve nitrogen oxide reduction under lean burn gasoline engine conditions. Model gas test results as well as engine bench data are used for discussion of the parameters which control NOx adsorption efficiency under various conditions. It is shown that the NOx adsorption technology enables an efficient removal of NOx up to 85% over a wide temperature range even at high NOx inlet concentrations. The major part of the paper is dedicated to the problem of sulfur poisoning under laboratory and engine operation conditions. The relationship between the uptake of poisons such as sulfur and phosphorus and the activity results is reported. It is demonstrated that relatively small amounts of adsorbed sulfur might cause a severe overproportional suppression of NOx storage activity. Regarding this, fundamental studies using various physicochemical and spectroscopic methods such as BET-surface area measurements, energy dispersive x-ray analysis (EDX), inductive coupled plasma (ICP) and x-ray fluorescence (XRF) were performed to elucidate the nature of sulfur deposition on the NOx storage catalyst. Some evidence exists that at short time-on-stream the SO3 reacts preferably with the NOx adsorbents by forming surface sulfate species which block off the active sites of the adsorbents for further NOx adsorption. However, by treating the, sulfur poisoned NOx storage catalysts with hydrogen the equivalent activity of the fresh catalyst can be restored. The results obtained by thermogravimetrical analyses coupled to a mass spectrometer (TG-MS) show that high concentrations of hydrogen bring about high levels of H2S and little SO2 whereas low concentrations of hydrogen preferably lead to increased SO2 emissions at expense of H2S. Another subject reported in detail is the progress made recently concerning improved sulfur tolerance of the technology by applying a sulfur trap mounted upstream to the NOx storage catalyst. The concept of the sulfur trap provides the periodical adsorption of SO3 whenever the exhaust is adjusted lean and the decomposition and emission of the sulfur as SO2 when the engine management provides the rich spikes. One target was to avoid the generation of H2S during the rich periods. Aided by the utilization of ion molecular reaction mass spectroscopy (IMR-MS) the general ability of the sulfur trap to function could be confirmed at different engine operating points and temperature levels. It is demonstrated that in the presence of sulfur a significant improvement in NOx activity retention by additionally applying the sulfur trap is feasible.
Citation: Strehlau, W., Leyrer, J., Lox, E., Kreuzer, T. et al., "New Developments in Lean NOx Catalysis for Gasoline Fueled Passenger Cars in Europe," SAE Technical Paper 962047, 1996, https://doi.org/10.4271/962047. Download Citation
W. Strehlau, J. Leyrer, E.S. Lox, T. Kreuzer, M. Hori, M. Hoffmann
Degussa AG, Nippon Shokubai Ltd., ICT Inc.
1996 SAE International Fall Fuels and Lubricants Meeting and Exhibition
SAE 1996 Transactions - Journal of Fuels and Lubricants-V105-4