Refine Your Search

Topic

Author

Affiliation

Search Results

Standard

Maximum Speed of Personal Watercraft

2023-12-13
CURRENT
J2882_202312
This SAE Standard establishes a uniform test procedure and performance requirement for limiting the maximum speed of a personal watercraft.
Standard

Standard Practice for Manpower and Personnel

2023-12-13
CURRENT
SAE1010A
This standard covers Manpower and Personnel (M&P) processes throughout planning, design, development, test, production, use, and disposal of a system. Depending on contract phase and/or complexity of the program, tailoring can be applied. The scope of this standard includes Prime and Subcontractor M&P activities; it does not include Government M&P activities. The primary goals of a contractor M&P program typically include: Ensuring that the system design complies with the latest customer Manpower estimates (numbers and mix of personnel, plus availability) and that discrepancies are reported to management and the customer. Ensuring that the system design is regularly compared to the latest customer personnel estimates (capabilities and limitations) and that discrepancies are reported to management and the customer.
Standard

Metallic Connections for Fluid Power and General Use - Part 3: NPTF Pipe Adapters and NPSM Adapter Unions

2023-12-13
CURRENT
J514/3_202312
This part of SAE J514 covers general and dimensional specifications for NPTF pipe adapters and 30 degree NPSM adapter unions. These fittings are intended for general application in hydraulic systems on industrial equipment and commercial products. These fittings are capable of providing leak-proof, full-flow connections in hydraulic systems operating at working pressures as specified in Table 6. Since many factors influence the pressure at which a hydraulic system will or will not perform satisfactorily, the values shown in Table 6 should not be construed as a guaranteed minimum. For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and fitting manufacturer to assure that performance levels will be safe and satisfactory.
Technical Paper

Optimizing the Design Parameters and Nanoclay Content of Thin GLARE Laminate Riveted Joints under Pull-Through Test Using Grey Relational Analysis

2023-12-13
2023-01-5086
The study investigates the optimization of design parameters of riveted joints such as diameter of rivet, edge distance, and the amount of nanoclay filler in the modified GLARE laminate single lap riveted joints under pull-through test. Taguchi’s L9 orthogonal array was used to plan the experiments. The failure mechanism of riveted joints was observed to be elongation of rivet hole, followed by stress concentration, crack initiation, propagation in the interface, coalition of multiple cracks leading to delamination in the laminate. The failure of joint finally occurred by rivet pin fracture. The regression equations were developed for both failure load and maximum displacements with prominent level of confidence and the reliability of the equations were confirmed by experiments. The effect of individual and interaction of factors was evaluated using analysis of variance (ANOVA).
Standard

Nickel Alloy, Corrosion and Heat Resistant, Sheet, Strip, and Foil, 52.5Ni - 19Cr - 3.0Mo - 5.0Cb - 0.90Ti - 0.50Al - 18Fe, Consumable Electrode or Vacuum Induction Melted, Precision Cold Rolled, Solution Heat Treated

2023-12-13
WIP
AMS5914C
This specification covers a precision cold rolled corrosion and heat resistant nickel alloy in the form of sheet and strip over 0.005 up to 0.015, inclusive, inch in nominal thickness and foil up to 0.005 inch, inclusive, in nominal thickness (see 8.5).
X