This specification covers the requirements for preparation of aluminum and aluminum alloys for soldering by zinc immersion pre-treatment followed by copper plating and tin or tin-zinc alloy plating.
This specification covers a polysulfide (T) rubber sealing compound with nonchromated corrosion inhibitors supplied as a two-component system which cures at room temperature.
This SAE Recommended Practice sets forth a method for measuring pressure-induced separation in automotive sealers and determining the likelihood of equipment failure due to this separation, also known as "caking."
This SAE Aerospace Recommended Practice (ARP) outlines a standard method for the checkout and calibration of electromagnetic interference measurement antennas. Its primary application is for use when measuring a source 1 m from the antenna in a shield room versus a source at a greater distance (far field). This is the typical distance used in performing military EMC testing. Thus, this is a method of calibration. Shield room characteristics are not considered. It does not address an unknown distributed source. Yet it is close to reality since it is based on another antenna that represents a distributed source. This document presents a technique to determine antenna factors for antennas used primarily in performing measurements in accordance with 2.1 and 2.2. The purpose of Revision B is to include the calibration of other antennas, such as small loop antennas that are also specified for use in these same references.
This SAE Recommended Practice defines a document for the format of messages and data that is of general value to modules on the data communications link. Included are field descriptions, size, scale, internal data representation, and position within a message. This document also describes guidelines for the frequency of and circumstances in which messages are transmitted. In order to promote compatibility among all aspects of electronic data used in heavy-duty applications, it is the intention of the Data Format Subcommittee (in conjunction with other industry groups) to develop recommended message formats for: a Vehicle and Component Information—This includes all information that pertains to the operation of the vehicle and its components (such as performance, maintenance, and diagnostic data). b Routing and Scheduling Information—Information related to the planned or actual route of the vehicle.
This SAE Standard provides test procedures, requirements, and guidelines for stop lamps and turn signal lamps intended for use on vehicles 2032 mm or more in overall width. Stop lamps and front- and rear-turn signal lamps conforming to the requirements of this document may be used on vehicles less than 2032 mm in overall width.
Published in 1996, as the 100th Anniversary of the automobile industry was celebrated in the United States, this book details the amazing story of how Detroit become the automobile capital of the U.S. All the of the automobile manufacturers in Detroit and surrounding areas are covered along with 49 additional topics that are woven in-between and presented in chronological order. This book includes over 500 time period photographs of factories, both inside and outside, personnel, cars, and logos. Readers will gain an appreciation for the talented people that created Detroit's automobile industry.
This specification establishes the engineering requirements for producing chemical-film coatings on aluminum alloys and the properties of such coatings.
This specification covers steel cleanliness requirements in inch/pound units for aircraft-quality ferro-magnetic steels, other than hardenable corrosion-resistant steels, by magnetic particle inspection methods.