Search Results

The introduction of this model eliminated prior limitations that PC-Crash had for simulating motorcycle motion. Within PC-Crash, a user-defined path can be established for a motorcycle, and the software will generate motion consistent with the user-defined path (within the limits of friction and stability) and calculate the motorcycle lean (roll) generated by following that path at the prescribed speed, braking, or acceleration levels. ...However, the model again did not utilize counter-steering to generate lean, and so it is unlikely that the steering inputs generated by PC-Crash would match the real-world steering inputs. Still, the PC-Crash single-track driver model will yield results that are typically adequate for a crash reconstruction or visualization. ...This paper validates the single-track vehicle driver model available in PC-Crash simulation software. The model is tested, and its limitations are described. The introduction of this model eliminated prior limitations that PC-Crash had for simulating motorcycle motion.

Using the PCM philosophy and including 5 seconds before the accident in the crash analysis combined with the driving behaviours of the vehicles out of PC-Crash, it is possible to analyse, whether or not a sensor system would have been able to recognise the dangerous situation in time to avoid or mitigate the accident.

The software packages included in the studies presented in this paper are HVE (SIMON and EDSMAC4), PC-Crash and VCRware. This paper will present the results of the study, conducted using DOE, involving these models.

Knowledge about vehicle rolling resistance is required to calculate speed loss of accident vehicles during portions of their pre-impact and post-impact trajectory when they are not braking or sliding directly sideways. The accuracy of assumed rolling resistance values is most important in accidents with long post-impact roll out distances. Very little hard data are currently available1 and the accident reconstructionist must usually make estimates of drivetrain losses and normal and damaged tire rolling resistance to determine overall vehicle rolling resistance. In the first part of this study, the rolling resistances of various vehicles with different drive configurations are determined, based on accurate measurements made with a 5th wheel. In the second part, sensitivity analyses are done with PC-Crash2, a computer simulation program, to determine what effect the error in assumed rolling resistance has on speed calculations for various types of post-impact trajectories.