Search Results

The application of press hardening steels (PHS) Al-Si coating has been increasing in body in white vehicles as an approach to meet the demands of safety and CO2 reduction regulations. The vehicle structures with PHS largely depend on the integrity and the mechanical performance of the spots weld. During the spot welding process, intermetallic phase may appear in function of the chemical composition of the steel and coating. One of these intermetallics is the Fe-Al phase which brittleness decreases the strength of the weld joint. In this study, resistance spot welding (RSW) experiments were performed in order to evaluate the influence of the welding parameters of single-lap joints PHS - 22MnB5 steel grade.

In the middle of the global competition, inside the automotive sector, the perceived quality of costumers, related to the beauty and harmony of the outer skin surfaces of motor vehicles, has become one of the main determinant factors in the purchase process decision. In general, the initial perceived quality of a car is determined by an appealing design of its body, the color and gloss of its paint, and also the manufacturing and assembly accuracy of the skin panels. The appealing design makes the skin panel even more complex and hard to produce with current metal forming technologies and the results are often small distortions on the outer surfaces about tens of microns and most of the times paint does not cover such imperfections. Despite the technological advances along the years, surface quality inspection was still being performed by manual and subjective evaluation by experts.

The globalization, rivalry and the technologies have changed the auto industry in a battlefield, where companies are fighting for quality, reliability, the reduction of development cycle and also cost. The manufacturing process of car body is the major responsible for time consumption, labor and investment. One of the bottleneck solutions is to use computational simulations during design phase in order to minimize the reworks. The car body is composed by several stamped parts, and its design requires a series of parallel activities, and one of the fundamental information is the accurate magnitude of spring back distortions, but due to the complexity of the phenomenon, the results are not so accurate as desired. The explored literatures are recommending numeric methods to simulate material's behavior and also the spring back phenomenon.

The current study has the proposal to approach the differences in dynamic behavior between camshaft manufactured in the traditional gray cast iron and an alloyed gray cast iron with the improvement on mechanical properties in order to stresses found on roller finger follower applied systems. The main objective of this paper is to show that camshaft made of modified gray cast iron and heat treated through the remelting process is still a good solution for application with roller finger followers systems which requires higher wear resistance standards. The proposed experimental study consists of comparative analysis of microstructure and hardness, dynamometers tests, dimensional measurements of camshafts, and after that, intends to show the higher performance of this manufacturing process in more severe applications of internal combustion engines.

This work presents aspects related to research and development of high-speed steels for valve seat inserts application. Five series of materials were evaluated: high speed steel M3/2 infiltrated with copper during sintering; high speed steel M3/2 with Cu3P addition; high speed steel M3/2 with Cu3P addition and further copper infiltrated during sintering; high speed steel M3/2 mixed with iron powder; high speed steel M3/2 mixed with iron powder and niobium carbide. The physical and mechanical properties of the evaluated high-speed steels are presented in terms of densification, hardness, and radial mechanical strength. These properties are compared according to the materials processing and heat treatment.