Refine Your Search

Date

Date

Emissions control Data management Combustion and combustion processes Engine efficiency Historical reference AMS F Corrosion Heat Resistant Alloys Committee Fuel consumption

Search Results

Viewing 1 to 20 of 64
123Next >Last >>
Sort by published
Standard

Calculation of Electron Vacancy Number in Superalloys
2019-07-24
CURRENT
AS5491D
This SAE Aerospace Standard (AS) establishes a uniform procedure for calculation of electron vacancy numbers in superalloys. It is intended for use by suppliers of raw materials and parts, typically castings, for which control of electron vacancy number is required by the raw material specification.
Standard

Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire
2019-05-10
CURRENT
AMS2261L
This specification covers established manufacturing tolerances applicable to bars, rods, and wire of nickel, nickel alloy, and cobalt alloys ordered to inch-pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "excl" is used to apply only to the higher figure of a specified range.
Standard

Elevated Temperature Tensile Properties of Castings
2019-04-15
CURRENT
AMS2361E
This specification establishes a procedure for designating minimum elevated temperature tensile property requirements of castings by means of this AMS number and a series of dash numbers.
Standard

Stress-Rupture Properties of Castings
2019-04-15
CURRENT
AMS2362D
This specification establishes a procedure for designating minimum stress-rupture property requirements of castings by means of this AMS number and a series of dash numbers.
Standard

Room Temperature Tensile Properties of Castings
2019-04-15
CURRENT
AMS2360E
This specification establishes a procedure for designating minimum room temperature tensile property requirements of castings by means of this AMS number and a series of dash numbers.
Standard

Tungsten Carbide-Cobalt Powder, Cast and Crushed
2019-03-28
WIP
AMS7879G
This specification covers tungsten carbide-cobalt in the form of powder. This powder has been used typically for producing plasma spray coatings to provide wear and fretting resistant surfaces, but usage is not limited to such applications.
Standard

Tolerances, Corrosion and Heat-Resistant Steel Tubing
2018-09-25
WIP
AMS2243L
This specification covers manufacturing tolerances applicable to seamless and welded tubing of corrosion and heat-resistant steel ordered to inch dimensions. These tolerances apply to all conditions and are based on individual measurements, unless otherwise noted. Tubing may be specified by two dimensions only (OD and wall thickness, ID and wall thickness, or OD and ID).
Standard

Heat Treatment Austenitic Corrosion-Resistant Steel Parts
2018-04-28
CURRENT
AMS2759/4D
This specification, in conjunction with the general requirements for steel heat treatment covered in AMS2759, establishes the requirements for annealing of austenitic corrosion-resistant steel parts. Parts are defined in AMS2759. General ordering instructions are specified in AMS2759.
123Next >Last >>
X