Refine Your Search

Search Results

Viewing 1 to 9 of 9
Standard

Turbine Flowmeter Fuel Flow Calculations

2015-09-07
CURRENT
ARP4990B
This SAE Aerospace Recommended Practice (ARP) provides to the aerospace industry a procedure for the consistent and accurate calculation of fuel flow using turbine flowmeters during development, production, and post overhaul/repair gas turbine engine testing.
Standard

Gas Turbine Engine Fuel Nozzle Test Procedures

2013-12-10
CURRENT
ARP4865A
The intent of this SAE Aerospace Recommended Practice (ARP) is to define and recommend to the Aerospace Industry standardized test procedures for establishing fuel nozzle operating performance including types of tests, controlled and measured parameters, and test configurations.
Standard

Turbine Flowmeter Fuel Flow Calculations

2013-10-04
HISTORICAL
ARP4990A
This SAE Aerospace Recommended Practice (ARP) provides to the aerospace industry a procedure for the consistent and accurate calculation of fuel flow using turbine flowmeters during development, production, and post overhaul/repair gas turbine engine testing.
Standard

Gas Turbine Engine Test Facility Audit Process

2012-05-16
CURRENT
ARP6196
This SAE Aerospace Recommended Practice provides recommendations for: the audit process in general; a list of specific areas of attention to be audited; maintaining the test facility in such a manner that it meets audit requirements.
Standard

Standard Specification for Turbine Flowmeters

2011-06-10
CURRENT
AS5304
This is a SAE Standard specification with minimum performance characteristics for Turbine Flowmeter (TFM) that pertains only to sizes from ½ to 2 inches. The utilization of TFM is for hydrocarbon liquid fuel volumetric flow measurements. This Standard specifically excludes smart electronics in accomplishing the defined performance objectives. Users of this Standard should specify other TFM characteristics required to satisfy their application and utilization in operational environment. A User should understand fit and function of the TFM and define end user specific fit and function requirements. The TFM should be calibrated by the manufacturer should be based upon end user requirements and presented as Roshko versus Strouhal at a reference temperature. The Supplier shall be prepared to show evidence to User that the device demonstrates compliance with all requirements identified in this Standard.
Standard

Trend Analysis for Maintaining Correlation of Gas Turbine Engine Test Cells

2011-03-10
HISTORICAL
ARP5758
This document describes a recommended practice and procedure for the trending of parameters to maintain the test cell correlation status. Trending is performed to monitor test cells for changes that can affect engine performance or the data acquired from engine tests.
Standard

TURBINE FLOWMETER FUEL FLOW CALCULATIONS

1997-09-01
HISTORICAL
ARP4990
This SAE Aerospace Recommended Practice (ARP) provides to the aerospace industry a procedure for the consistent and accurate calculation of fuel flow using turbine flowmeters during development, production, and post overhaul/repair gas turbine engine testing.
Standard

GAS TURBINE ENGINE FUEL NOZZLE TEST PROCEDURES

1997-01-01
HISTORICAL
ARP4865
The intent of this SAE Aerospace Recommended Practice (ARP) is to define and recommend to the Aerospace Industry standardized test procedures for establishing fuel nozzle operating performance including types of tests, controlled and measured parameters, and test configurations.
X