Refine Your Search

Topic

Author

Search Results

Standard

Active Safety Systems Terms & Definitions

2019-09-18
WIP
J3063
This SAE Technical Information Report provides a compendium of terms, definitions, abbreviations, and acronyms to enable common terminology for use in engineering reports, diagnostic tools and publications related to active safety systems. This information report is a survey of active safety systems and related terms. The definitions offered are descriptions of functionality rather than technical specifications. Included are warning and momentary intervention systems, which do not automate any part of the dynamic driving task on a sustained basis like those defined in SAE J3016 Automated Driving Systems.
Standard

Aluminum Alloy Forgings and Rolled Rings, 4.4Cu - 0.85Si - 0.80Mn - 0.50Mg (2014-T6), Solution and Precipitation Heat Treated

2019-09-18
WIP
AMS4133F
This specification covers an aluminum alloy in the form of die forgings, hand forgings, rolled rings, and forging stock. These products have been used typically for aircraft structural members requiring moderately high strength. Certain design and processing procedures may cause these forgings and rolled rings to become susceptible to stress-corrosion cracking; ARP823 recommends practices to minimize such conditions.
Standard

Aluminum Alloy Extrusions 7.8Zn - 2.6Mg - 2.0Cuu - 0.10Zr (7068-T6511) Solution Heat Treated, Stress Relieved, and Precipitation Heat Treated

2019-09-18
WIP
AMS4331A
This specification covers an aluminum alloy in the form of extruded bars, rods, shapes (profiles), and tubing.

These extrusions have been used typically for structural parts requiring a combination of high tensile strength and moderate fatigue strength, but usage is not limited to such applications.

Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking; SAE ARP 823 recommends practices to minimize such conditions.

Standard

Recommended Environmental Practices for Electronic Equipment Design in Heavy-Duty Vehicle Applications

2019-09-17
WIP
J1455
The scope of this Recommended Practice encompasses the range of environments which influence the performance and reliability of the electronic equipment designed for heavy duty on and off road vehicles, as well as any appropriate stationary applications which also use these vehicle derived components. A few examples of such vehicles are on and off highway trucks, trailers, buses, construction equipment, and agricultural equipment including implements.
Standard

Rivets, Carbon Steel Procurement Specification for

2019-09-16
WIP
AS7225B
This procurement specification covers aircraft-quality solid rivets and tubular end rivets made from a carbon steel of the type identified under the Unified Numbering System as UNS G10100.

Primarily for joining steel parts where a low shear strength is adequate and destruction of the fastener for repair or replacement is permissible.

Standard

Seven Conductor Cable - Truck and Bus

2019-09-12
WIP
J1067
This SAE standard establishes the minimum construction and performance requirements for seven conductor 1/8 1/10 5/12 cable for use on trucks, trailers and converter dollies. Where appropriate, the standard refers to two types of cables, (Type F and S, described later in the standard), due to the variation in the performance demands of cables used in flexing and stationary applications.
X