Refine Your Search

Topic

Search Results

Standard

Rings, Sealing, Butadiene-Acrylonitrile (Nbr) Rubber Synthetic Lubricant Resistant 67-75

2018-10-09
WIP
AMS7272H
This specification covers a butadiene-acrylonitrile (NBR) rubber in the form of molded rings. These rings have been used typically as sealing rings in contact with diester synthetic lubricants in service up 150 degrees C (302 degrees F), but usage is not limited to such applications. The cross-section of such rings is usually not over 0.275 inch (6.98 mm) in diameter or thickness.
Standard

Rubber: Flourocarbon (FKM), High Temperature/Fluid Resistant, Low Compression Set/ 85 to 95 Hardness, For Seals in Fuel Systems and Specific Engine Oil Systems

2018-10-09
WIP
AMS7259F
This specification covers a fluorocarbon (FKM) rubber in the form of O-rings, O-ring cord, compression seals, and molded-in-place gaskets for aeronautical and aerospace applications. These products have been used typically as sealing rings, compression seals, O-ring cord, and molded-in-place gaskets in contact with air and a wide variety of fuels, lubricants, and specific hydraulic fluids but usage is not limited to such applications. Each application should be considered individually. This class of fluoroelastomers is not recommended for use in high temperature stabilized, “HTS”, engine oils. Each “HTS” oil should be evaluated separately. This fluorocarbon rubber has a typical service temperature range of -20 to +400 °F (-29 to +204 °C) in air.
Standard

Age Control of Age Sensitive Elastomeric Materials

2018-04-11
CURRENT
AIR1364B
This SAE Aerospace Information Report (AIR) summarizes data and background relative to age control of specific classes of those nitrile type synthetic elastomers used in sealing devices which are resistant to petroleum base hydraulic fluids, lubricating oils, and aircraft fuels. This includes, but is not limited to, those nitrile (NBR or BUNA-N) elastomers previously covered by Section I of MIL-STD-1523.
Standard

Designing for Long Life with Elastomers

2018-01-04
CURRENT
AIR1412D
This document lists those guidelines recognized as being essential for consideration by the designer who is preparing to select an elastomer as part of an aerospace design.
Standard

Manufacturing Processing Requirements for Molded Elastomer Components Used in Aerospace Applications

2017-06-22
CURRENT
AS6414A
This specification is applicable to the processes that are used in the manufacture of aerospace elastomer parts utilizing materials conforming to AMS7XXX series specifications, user specifications, or print on a Purchase Order (PO) that calls out this document for aerospace applications. The elastomer parts are in the form of O-rings, plate seals and other compression seals.
Standard

Packaging and Identification of Molded Elastomeric Seals and Sealing Components

2016-11-22
CURRENT
AMS2817G
This specification covers procedures which will provide protection of elastomeric seals and seal assemblies such as O-rings, cap seal assemblies, and other designs from contamination by foreign materials and handling / transportation / storage damage prior to installation and ensure positive identification by part number of each piece until it is installed.
X