Refine Your Search

Search Results

Viewing 1 to 9 of 9
Standard

Fuel and Oil Hoses

2019-03-12
WIP
J30
This SAE standard covers fuel, oil, or emission hose for use in coupled and uncoupled applications, for use with gasoline, oil, diesel fuel, lubrication oil, or the vapors present in either the fuel system or in the crankcase of internal combustion engines in mobile or stationary applications. This standard covers the hose portion only. If assembly / coupling is required, that is to be agreed to between the customer and assembler, along with the specific requirements.
Standard

Coolant System Hoses

2019-03-08
WIP
J20
This SAE Standard covers reinforced and flexible hoses intended for use in water and ethylene glycol based engine-coolant system applications.
Standard

Hose Clamp Specifications

2019-01-15
WIP
J1508
This SAE Standard covers thirty-two (32) types of clamps most commonly and suitably being used on OEM coolant, fuel, oil, vacuum, and emission systems.
Standard

Test Method for Evaluating the Electrical Resistance of Coolant System Hose Covers

2018-09-18
WIP
J2790
This test method provides a standardized procedure for evaluating the electrical resistance of automotive coolant hose covers. It is know that an electrical potential exists between the engine and the radiator. Coolant hose cover conductivity has been determined to be a factor in reduced hose clamp life when vehicle build variations allow possible contact of the hose or the clamp to contact metal components on the radiator and engine thus completing an electrical circuit. The ensuing electrical current can undercut the clamp protective coating, leaving it vulnerable to the corrosive effects of road salts, moisture, and other environmental contaminants. SAE Recommended Practice J1684 addresses the conductivity of the tube portion of the coolant hose.
Standard

Compression Set of Hoses or Solid Discs

2015-04-21
CURRENT
J1638_201504
This SAE Recommended Practice is used for establishing the compression set that could be expected to occur with a thermoset elastomeric hose under securing clamps. It seeks to reproduce the type of indentation caused by the clamps in the wall of a hose. An excessive compression set measured by this method may indicate a hose that could eventually allow leakage of fluid or gas past the clamps in service.
Standard

Windshield Washer Tubing

2015-04-21
CURRENT
J1037_201504
This SAE Standard covers nonreinforced, extruded, flexible tubing intended primarily for use as fluid lines for automotive windshield washer systems which conform to the requirements of SAE J942.
Standard

Hose Clamp Specifications

2009-03-06
CURRENT
J1508_200903
This SAE Standard covers thirty-two (32) types of clamps most commonly and suitably being used on OEM coolant, fuel, oil, vacuum, and emission systems.
Standard

Type "F" Clamps for Plumbing Applications

2008-12-02
CURRENT
J1670_200812
This SAE Standard covers complete dimensional and general specifications for worm drive hose clamps for general use in the plumbing industry.
Standard

Windshield Washer Tubing

2006-03-03
HISTORICAL
J1037_200603
This SAE Standard covers nonreinforced, extruded, flexible tubing intended primarily for use as fluid lines for automotive windshield washer systems which conform to the requirements of SAE J942.
X