Search Results

Aircraft engine power is degraded with increasing altitude according to the resultant reduction in air pressure, temperature, and density. One way to mitigate this problem is through turbo-normalization of the air being supplied to the engine. Supercharger and turbocharger components suffer from a well-recognized loss in efficiency as they are scaled down in order to match the reduced mass flow demands of small-scale Internal Combustion Engines. This is due in large part to problems related to machining tolerance limitations, such as the increase in relative operating clearances, and increased blade thickness relative to the flow area. As Internal Combustion Engines decrease in size, they also suffer from efficiency losses owing primarily to thermal loss. This amplifies the importance of maximizing the efficiency of all sub-systems in order to minimize specific fuel consumption and enhance overall aircraft performance.

In this work we present our recent effort in developing a novel heat exchanger based on endothermic chemical reaction (HEX reactor). The proposed HEX reactor is designed to provide additional heat sink capability for aircraft thermal management systems. Ammonium carbamate (AC) which has a decomposition enthalpy of 1.8 MJ/kg is suspended in propylene glycol and used as the heat exchanger working fluid. The decomposition temperature of AC is pressure dependent (60°C at 1 atmosphere; lower temperatures at lower pressures) and as the heat load on the HEX increases and the glycol temperature reaches AC decomposition temperature, AC decomposes and isothermally absorbs energy from the glycol. The reaction, and therefore the heat transfer rate, is controlled by regulating the pressure within the reactor side of the heat exchanger. The experiment is designed to demonstrate continuous replenishment of AC.

Lithium ion conductivity of a lithium compound is known to be influenced by an inert, non-lithium ion conductor additive. This paper reports an investigation of the effects of boron nitride (BN) addition to the conductivity of lithium iodide (Lil). The Lil:BN stoichiometry and heat treatment parameters (temperature and time) have been used as variables. It will be shown that lithium conductivity is strongly dependent upon heat treatment parameters. The activation energy for lithium ion transport also decreases with the addition of BN. Further analysis of activation energy data suggests that lithium ion motion takes place through interfacial regions of Lil and BN phases.

Numerical simulations indicate that blast loading on aircraft structural joints can impart loading rates in excess of 10 Mlb/sec (ten million pounds per second, Reference 1). Experimental evidence, on the other hand, suggests that mechanical joint failure loads are highly loading rate dependent; for example, the failure load for a dynamically loaded tension joint can double from its static value. This paper discusses the progress and to-date findings of research on the assessment of strength failure of aircraft structural joints subjected to loading rates expected from an internal explosive detonation, and several associated experimental procedures to generate such dynamic loading. This work is conducted at MDC and at the University of Dayton Research Institute (UDRI) in support of the FAA Aircraft Hardening Program.

We have developed a pilot's harness-mounted, high-voltage quick-disconnect connector for a binocular, helmet-mounted display system. It connects and disconnects with power off, and disconnects “hot” without pilot intervention, external sparks, or exposed hot embers in the explosive environment of the cockpit. Furthermore, we have successfully implemented a procedure in which high-voltage pins of up to 13.5 kV disconnect inside a hermetically sealed unit before the physical separation of the connector. The locations of the conductors and shields are designed to avoid crosstalk among adjacent circuits. The connector shell is equipped to house and cool two hybrid video amplifiers that provide up to 70 MHz video bandwidth to the helmet-mounted CRTs. The connector has been human-engineered to facilitate the arm, head, and torso movements of the pilot. Shielded cables and wires are potted as a multilayered ribbon for maximum flexibility between the connector and helmet.