Refine Your Search

Date

Date

Topic

Topic

Hydrocarbons Parts and Components On-board energy sources AE-8A Elec Wiring and Fiber Optic Interconnect Sys Install

Search Results

Viewing 1 to 20 of 56
123Next >Last >>
Sort by published
Standard

EWIS Wiring Insulation Breakdown Testing
2022-09-30
CURRENT
ARP6216
This SAE Aerospace Recommended Practice (ARP) identifies the minimum requirements for the testing of insulated electrical wiring for on-aircraft, aeronautical and aerospace applications. The testing requirements defined herein, ensure that a wire fault can be found safely when using a high potential voltage tester (hipot). This test is intended to aid in finding a breach in the wire insulation, and not for the identification of the resistance of the insulation. The test method defined herein is limited to equipment which ia able to control and limit the DC output to 1500 VDC maximum. This type of wire dielectric tester is typically designed to trip on current leakage and not necessarily on arc detection. This test method is solely designed to identify gross/large wire insulation damage or degradation. For additional related information on this topic and related test methods, refer to the documents cited in Section 2.
Standard

Transmission Lines, Transverse Electromagnetic Mode
2020-10-30
CURRENT
ARP81490B
This document covers the general recommendations for Transverse Electromagnetic Mode (TEM) Transmission Lines intended for use in airborne systems (see 6.2.14). For U.S military applications, TEM Transmission Lines shall meet the requirements in accordance with MIL-T-81490. The follow index lists the recommended requirements and methods covered by the Aerospace Recommended Practice (ARP):
Standard

Electrical Wiring Fuel Compatibility
2020-09-18
CURRENT
AIR6820A
This SAE Aerospace Information Report (AIR) is limited to the subject of compatibility of wiring as part of aircraft Electrical Wiring and Interconnect Systems (EWIS) installed in and around aircraft fuel tanks.
Standard

Design and Handling Guide Radio Frequency Absorptive Type Wire and Cables (Filter Line, AS85485)
2020-01-31
CURRENT
AIR4465A
This document presents design and application information which will allow optimized utilization of filter line wire and cable purchased to AS85485. Filter line wire is defined and design information is presented. The electrical and mechanical performance characteristics of the wire, along with recommended harnessing methods and techniques, are also presented.
Standard

Mitigating Wire Insulation Damage During Processing and Handling
2019-12-27
CURRENT
AIR5717
Wire and cable products progress through a series of handling or operational steps from the time they leave the manufacturer, and until a finished harness or assembly is ready for installation on a vehicle. Throughout these many steps, environmental or processing conditions may be present which can generate damage detrimental to the wire or cable and/or its intended application.
Standard

Etching of Fluoropolymer Insulations
2019-06-11
CURRENT
ARP6167
This SAE Aerospace Recommended Practice (ARP) describes the etching of fluoropolymer electrical wire insulations to ensure that all facets of the process from the chemistry to the processing, to the storage and handling are well defined.
Standard

Electrical Wiring Fuel Compatibility
2018-12-12
HISTORICAL
AIR6820
This SAE Aerospace Information Report (AIR) is limited to the subject of compatibility of wiring as part of aircraft Electrical Wiring and Interconnect Systems (EWIS) installed in and around aircraft fuel tanks.
123Next >Last >>
X