Refine Your Search

Topic

Search Results

Standard

Heat Treatment of Parts in a Vacuum

2019-07-12
CURRENT
AMS2769C
This specification establishes the requirements and procedures for heat treating parts in vacuum/partial pressure and shall be used as a supplementary document to primary heat treating specifications as applicable.
Standard

Tolerances Nickel, Nickel Alloy, and Cobalt Alloy Bars, Rods, and Wire

2019-05-10
CURRENT
AMS2261L
This specification covers established manufacturing tolerances applicable to bars, rods, and wire of nickel, nickel alloy, and cobalt alloys ordered to inch-pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "excl" is used to apply only to the higher figure of a specified range.
Standard

Elevated Temperature Tensile Properties of Castings

2019-04-15
CURRENT
AMS2361E
This specification establishes a procedure for designating minimum elevated temperature tensile property requirements of castings by means of this AMS number and a series of dash numbers.
Standard

Stress-Rupture Properties of Castings

2019-04-15
CURRENT
AMS2362D
This specification establishes a procedure for designating minimum stress-rupture property requirements of castings by means of this AMS number and a series of dash numbers.
Standard

Room Temperature Tensile Properties of Castings

2019-04-15
CURRENT
AMS2360E
This specification establishes a procedure for designating minimum room temperature tensile property requirements of castings by means of this AMS number and a series of dash numbers.
Standard

Tungsten Carbide-Cobalt Powder, Cast and Crushed

2019-03-28
WIP
AMS7879G
This specification covers tungsten carbide-cobalt in the form of powder. This powder has been used typically for producing plasma spray coatings to provide wear and fretting resistant surfaces, but usage is not limited to such applications.
Standard

Nickel Wire and Ribbon 99Ni

2019-01-07
CURRENT
AMS5555F
This specification covers a nickel in the form of round wire and rectangular ribbon.
Standard

Tolerances, Corrosion and Heat-Resistant Steel Tubing

2018-09-25
WIP
AMS2243L
This specification covers manufacturing tolerances applicable to seamless and welded tubing of corrosion and heat-resistant steel ordered to inch dimensions. These tolerances apply to all conditions and are based on individual measurements, unless otherwise noted. Tubing may be specified by two dimensions only (OD and wall thickness, ID and wall thickness, or OD and ID).
X