Refine Your Search

Topic

Search Results

Standard

Groove Design - Metal Face Seal

2019-06-06
CURRENT
AIR1108A
Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS202 thru MS9205) where interchangeability with machined or formed metal seals is desired. For metal o-ring groove designs where inter-changeability is not a requirement refer to ARP 674.
Standard

Bolts, Cobalt-Chromium-Nickel Alloy, Uns R30035, Tensile Strength 260 Ksi, Procurement Specification

2018-12-07
WIP
AS7468C
This procurement specification covers bolts made from a corrosion resistant, work-strengthened, cobalt-chromium-nickel alloy of the type identified under the Unified Numbering System as UNS R30035. The following specification designations and their properties are covered: AS7468 260 ksi minimum ultimate tensile strength at room temperature, 135 ksi tension to 13.5 ksi tension fatigue at room temperature; and AS7468-1 260 ksi minimum ultimate tensile strength at room temperature, 145 ksi minimum ultimate shear strength at room temperature.
Standard

Limits, Table of Limits and Lubrication Charts

2018-09-11
CURRENT
AS176D
This specification covers the requirements for the preparation of Limits, Table of Limits and Lubrication Charts in published form for service and production use.
Standard

Nut, Self Locking - UNS S66286, 425°C & 650°C, 1100 MPa, MJ Thread, Procurement Specification For, Metric

2018-03-30
CURRENT
MA1568A
This specification establishes the requirements for the following types of self locking nuts: a Wrenching nuts: i.e., hex, double hex, spline drive. b Anchor nuts: i.e., plate nuts, gang channel nuts, shank (clinch) nuts. The wrenching nuts, shank nuts, and nut elements of plate and gang channel nuts are made of corrosion and heat resistant steel of the type identified under the Unified Numbering System as UNS S66286.
Standard

Torque Tightening Threaded Fasteners

2018-03-04
CURRENT
AIR1471B
The purpose of this SAE Aerospace Information Report (AIR) is to provide the aerospace propulsion industry with recommended assembly torque limits for commonly used aircraft propulsion system threaded fasteners when a common torque value per size is the objective.
Standard

Lubricant, Solid Film

2017-01-10
CURRENT
AS1701F
This document covers the performance requirements for solid dry film lubricants, air dried or heat cured, for use in aerospace applications. These lubricants are intended to prevent galling, and may be capable of remaining effective for extended periods of time after exposure to extreme environmental conditions.
Standard

Studs, Steel, Low Alloy Heat Treated, Roll Threaded

2016-04-20
CURRENT
AS7456C
This procurement specification covers aircraft quality studs made from a low alloy steel of the type identified under the Unified Numbering System as UNS G87400, and of a series of room temperature tensile strengths ranging from 125000 to 185000 psi.
X