Refine Your Search

Date

Date

Topic

Topic

AMS K Non Destructive Methods and Processes Committee Fabrics and textiles Fibers Standard Materials properties Metallurgy

Search Results

Viewing 1 to 20 of 76
123Next >Last >>
Sort by published
Standard

Magnetic Particles, Nonfluorescent Wet Method, Oil Vehicle, Ready-to-Use
2023-02-20
CURRENT
AMS3041G
This specification covers nonfluorescent magnetic particles in the form of a mixed, ready-to-use suspension in an odorless inspection oil vehicle. The magnetic particles shall be in the form of either a single material or composite material as defined in 1.3.
Standard

Magnetic Particles, Nonfluorescent Wet Method, Dry Powder
2022-08-05
CURRENT
AMS3042G
This specification covers nonfluorescent, magnetic particles in the form of dry powders in the form of single or composite magnetic particle intended to be suspended in oil or conditioned water vehicle for use in the wet method, magnetic particle inspection.
Standard

Inspection Material, Penetrant
2021-04-30
WIP
AMS2644J
This specification establishes the classification, technical requirements, tests, and test procedures for the qualification, approval, and quality verification of all materials used in the liquid penetrant methods of inspection with the exception of those excluded in the application section.
Standard

Inspection Material, Penetrant
2020-07-14
CURRENT
AMS2644H
This specification establishes the classification, technical requirements, tests, and test procedures for the qualification, approval, and quality verification of all materials used in the liquid penetrant methods of inspection with the exception of those excluded in the application section.
Standard

Eddy Current Inspection of Circular Holes in Nonferrous Metallic Aircraft Engine Hardware
2019-10-14
CURRENT
AS4787A
This SAE Aerospace Standard (AS) establishes minimum requirements for eddy current inspection of circular holes in nonferrous, metallic, low conductivity (less than 5% IACS) aircraft engine hardware with fasteners removed. The inspection is intended to be performed at maintenance and overhaul facilities on engine run hardware.
Standard

Ultrasonic Inspection Thin Wall Metal Tubing
2019-04-24
HISTORICAL
AMS2634B
This specification covers procedures for ultrasonic inspection of thin wall metal tubing of titanium, titanium alloy, and corrosion and heat resistant steels and alloys having nominal OD over 0.1875 inch (4.762 mm) with OD to wall thickness ratio of 8 or greater and wall thickness variation not exceeding ±10% of nominal.
Standard

Ultrasonic Thickness Testing
2018-09-21
HISTORICAL
ARP2654
To provide general instructions for accomplishing ultrasonic thickness measurements. Measurements can be made from one side of a material when access to the opposite side is restricted.
Standard

Inspection Process, Magnetic Rubber
2016-01-06
CURRENT
AMSI83387B
This specification covers both the material and the examination process of an inspection material in the form of a dispersion of magnetic particles in a controlled viscosity rubber base that cures at room temperature by addition of one or more curing agents. The test object is magnetized with the uncured rubber covering the area of interest. The magnetic particles then migrate to the leakage field caused by the discontinuity. As the rubber cures, discontinuity indications remain in place on the rubber. The product may be supplied in a variety of viscosities and colors.
123Next >Last >>
X