Search Results

The beneficial effects of contact disruption in modulation-assisted machining of aerospace alloys have been well documented, but sources for such improvements are not well understood. This study explores the underlying nature of differences that occur in energy dissipation during conventional and modulation-assisted machining by characterizing the relationship between controllable process parameters and their effects on chip formation. Simultaneous in situ force and tool position measurements are used to show that the forces in modulation-assisted machining can be described by empirical force models in conventional machining conditions. These models are found to accurately describe plastic dissipation over a range of modulation conditions and configurations, including in cases where energy expenditure decreases with the application of modulation. These observations suggest that the underlying response in modulation-assisted machining is analogous to that of conventional machining.

This paper is part of a larger body of experimental and computational work devoted to studying the role of close-coupled post injections on soot reduction in a heavy-duty optical engine. It is a continuation of an earlier computational paper. The goals of the current work are to develop new CFD analysis tools and methods and apply them to gain a more in depth understanding of the different in-cylinder environments into which fuel from main- and post-injections are injected and to study how the in-cylinder flow, thermal and chemical fields are transformed between start of injection timings. The engine represented in this computational study is a single-cylinder, direct-injection, heavy-duty, low-swirl engine with optical components. It is based on the Cummins N14, has a cylindrical shaped piston bowl and an eight-hole injector that are both centered on the cylinder axis. The fuel used was n-heptane and the engine operating condition was light load at 1200 RPM.

Mn and/or rare earth-doped xCaTiO₃ - (1-x)CaMeO₃ dielectrics, where Me=Hf or Zr and x=0.7, 0.8, and 0.9 were developed to yield materials with room temperature relative permittivities of Εr ~ 150-170, thermal coefficients of capacitance (TCC) of ± 15.8% to ± 16.4% from -50 to 150°C, and band gaps of ~ 3.3-3.6 eV as determined by UV-Vis spectroscopy. Un-doped single layer capacitors exhibited room temperature energy densities as large as 9.0 J/cm₃, but showed a drastic decrease in energy density above 100°C. When doped with 0.5 mol% Mn, the temperature dependence of the breakdown strength was minimized, and energy densities similar to room temperature values (9.5 J/cm₃) were observed up to 200°C. At 300°C, energy densities as large as 6.5 J/cm₃ were measured. These observations suggest that with further reductions in grain size and dielectric layer thickness, the xCaTiO₃ - (1-x)CaMeO₃ system is a strong candidate for integration into future power electronics applications.

Zinc oxide based metal oxide varistors (MOV) are widely used electrical surge protection components. Modern high power, high-density electronics post more requirements such as smaller footprints, higher current density and higher nonlinearity on MOVs. Such requirements can no longer be satisfied by commercially available MOVs due to their limited voltage capability, high leakage current and mechanical cracking related reliability issues, most of which are associated with the presence of non-uniformity, defects and coarse grain in their micro-structures. New formulations and processes have been developed to overcome such limitations. This work has identified compositions that can be sintered at relatively lower temperatures than typical commercial MOVs, but with largely improved I-V characteristics due to refined and uniform microstructure.

A NEW arctic engine oil, designed to permit cold-weather operation of Army equipment, has been tested to determine required cranking effort. Data obtained are to be used to design new cranking equipment and to estimate the temperature limits of existing cranking equipment. Tests were conducted on six gasoline engines and five diesel engines using the new oil conforming to MIL-O-10295. Cranking the engines through a torquemeter permitted direct measurement of cranking torque. The results of the investigation are presented in this paper.