Refine Your Search

Date

Date

Topic

Topic

Aircraft structures Parts and Components ACBG Plain Bearing Committee

Search Results

Viewing 1 to 20 of 197
123Next >Last >>
Sort by published
Standard

Plain Bearing Low Speed Oscillation Test
2021-09-28
WIP
ARP5448/3B
This test method outlines a recommended procedure for performing unidirectional load dynamic testing of self-lubricating bearings at room temperature, elevated temperature or sub-zero temperature, dry or contaminated with fluids. The wear data from these tests is to be used for qualification and to establish bearing design criteria.
Standard

Plain Bearing Low Speed Oscillation Test
2016-07-19
CURRENT
ARP5448/3A
This test method outlines a recommended procedure for performing unidirectional load dynamic testing of self-lubricating bearings at room temperature, elevated temperature or sub-zero temperature, dry or contaminated with fluids. The wear data from these tests is to be used for qualification and to establish bearing design criteria.
Standard

Plain Bearing Low Speed Oscillation Test
2010-06-25
HISTORICAL
ARP5448/3
This test method outlines a standard procedure for performing unidirectional load dynamic testing of self-lubricating bearings at room temperature, elevated temperature or sub-zero temperature, dry or contaminated with fluids. The wear data from these tests is to be used for qualification and to establish bearing design criteria.
Standard

Bearings, Plain, Self-Aligning, Self-Lubricating, 300 cpm Oscillation (13 fpm), -65 to +160 °F (-54 to +71 °C), Liners Less Than 0.015 inches
2018-08-23
CURRENT
AS82819
This standard covers the requirements for spherical, self-aligning, self-lubricating, bearings which are for use in the ambient temperature range of -65 to +160 °F (-54 to +71 °C) at high cyclic speeds 300 cpm (13 fpm) for liners with a thickness less than 0.015 inch. The scope of this standard is to provide a liner system qualification procedure for helicopter sliding bearings defined and controlled by source control drawings. Once a liner system is qualified, the source-controlled bearings are further tested under application conditions. Under Department of Defense (DoD) Policies and Procedures, any qualification requirements and associated Qualified Products List (QPLs) are mandatory for DoD contracts. Any materials relating to QPLs have not been adopted by SAE and are not part of this SAE technical document.
Standard

Bearings, Elastomeric General Specification for
2021-02-11
CURRENT
AS85598
This standard defines general requirements for spherical, radial-journal, conical, and thrust bearings which are of laminated elastomeric construction. These bearings are for use in an environment having a temperature spectrum of -65 to +160 °F while reacting steady state loads in addition to oscillating loads and motions. The operating temperature range of -65 to +160 °F reflects the current temperature range for existing parts, but allows for expansion in the future.
123Next >Last >>
X