Refine Your Search

Search Results

Viewing 1 to 5 of 5
Technical Paper

Investigation of the Effects of Autoignition on the Heat Release Histories of a Knocking SI Engine Using Wiebe Functions

2008-04-14
2008-01-1088
In this paper, we develop a methodology to enable the isolation of the heat release contribution of knocking combustion from flame-propagation combustion. We first address the empirical modeling of individual non-autoigniting combustion history using the Wiebe function, and subsequently apply this methodology to investigate the effect of autoignition on the heat release history of knocking cycles in a spark ignition (SI) engine. We start by re-visiting the Wiebe function, which is widely used to model empirically mass burned histories in SI engines. We propose a method to tune the parameters of the Wiebe function on a cycle-by-cycle basis, i.e., generating a different Wiebe to suitably fit the heat release history of each cycle. Using non-autoigniting cycles, we show that the Wiebe function can reliably simulate the heat release history of an entire cycle, if only data from the first portion of the cycle is used in the tuning process.
Technical Paper

Intake-Valve Temperature and the Factors Affecting It

1997-05-05
971729
Steady-state temperature measurements were made at two locations on the back surface of the intake valves of one of the cylinders of a Saturn 1.9-L DOHC engine. The temperature locations were such that in the upstream location the thermocouple is subjected to the impingement of the fuel spray during the injection process, whereas in the downstream location the thermocouple is out of the main fuel spray. The measured intake valve temperature at the upstream location was significantly lower than that at the downstream location, which was attributed to the spray cooling effect. The intake valve temperature was found to increase with increasing load, speed and coolant temperature. As the air-fuel ratio changes the valve temperature exhibits a maximum at near stoichiometric compositions, which is attributed to convective heat transfer from the backflow of combustion gases during the valve-overlap period.
Technical Paper

Intake-Valve Temperature Histories During S.I. Engine Warm-Up

2001-05-14
2001-01-1704
The present study is an experimental investigation on the influence of engine operational parameters on the temperature history of intake valves. During the initial stage of the warm-up process, the temperature history of the intake valve followed an exponential behavior with a time constant that ranged from about 23 to 39 s for the test conditions examined. In contrast, the temperature history of the coolant varied linearly with time suggesting that the net heat input to the coolant is roughly constant during the initial stage of the engine warm-up process. After the initial transient phase that lasted about one minute, the temperature rise of the intake valve was quasi-steady. During this latter period, the measured intake valve temperature was predicted by the steady-state temperature correlation developed in an earlier study.
Technical Paper

Effects of Operational Parameters on Structural Temperatures and Coolant Heat Rejection of a S. I. Engine

1993-04-01
931124
This study reports the effects of various engine operational parameters and coolant conditions on the structural temperature distribution, and on the heat rejection to the coolant and to the lubricating oil of a 16-valve 4-cylinder engine. Included are comparisons of the cooling characteristics of the aqueous solution coolant with those of 100% ethylene glycol coolant. Lastly, an empirical equation for the coolant heat rejection of this engine is presented.
Technical Paper

Impact of Engine Design on Vehicle Heating System Performance

1997-05-19
971839
A global thermal model of a vehicle powertrain is used to quantify how different engine design and powertrain calibration strategies influence the performance of a vehicle heating system. Each strategy is evaluated on its ability to improve the warm-up and heat rejection characteristics of a small-displacement, spark-ignition engine while minimizing any adverse effect on fuel consumption or emissions. An energy audit analysis shows that the two strategies having the greatest impact on heating system performance are advancing the spark and forcing the transmission to operate in a lower gear. Changes in head mass, exhaust port diameter, and coolant flow rate influence the coolant warm-up rate but have relatively little effect on steady state heat transfer at the heater core.
X