Search Results

Various techniques to reduce the aerodynamic drag of bluff bodies through the mechanism of base pressure recovery have been investigated. These include, for example, boat-tailing, base cavities and base bleed. In this study a simple body representing a car shape is modified to include tapering of the rear upper body on both roof and sides. The effects of taper angle and taper length on drag and lift characteristics are investigated. It is shown that a significant drag reduction can be obtained with moderate taper angles. An unexpected feature is a drag rise at a particular taper length. Pressure data obtained on the rear surfaces and some wake flow visualisation using PIV are presented.

The vortex structure in the wake of a car creates drag. In the case of a simple wing this drag component is well defined as a function of lift, but for road vehicles the relationship is more complex. The backlight surface has been shown to be a significant source of vortex drag and in this paper the influence of backlight aspect ratio on both vortex and base drag is investigated. The vortex drag factor is found to be independent of aspect ratio, while the base drag component is shown to be dependent on the ratio of base to frontal area.

Aerodynamic aids, such as spoilers, applied to the rear of cars can provide drag reduction to improve performance, or can enhance high speed stability by reducing lift at the rear axle. In some cases these can be conflicting demands. It has been noted, however, that when rear axle lift is reduced there is often a reduction in yawing moment which has a beneficial effect on crosswind sensitivity. Wind tunnel results from real road vehicles are presented to illustrate this effect. This beneficial relationship is further explored in a wind tunnel experiment using simple models to represent road vehicles. Force and moment coefficients as a function of yaw angle are measured for a range of vehicle geometries which generate a substantial variation in lift. It is shown that as lift is reduced, yawing moment is also reduced, while side force and rolling moment are increased.

Side force has an influence on the behaviour of passenger cars in windy conditions. It increases approximately linearly with yaw angle over a significant range of yaw for almost all cars and the side force derivative, (the gradient of side force coefficient with yaw angle), is similar for vehicles of a given category and size. The shape factors and components which affect side force for different vehicle types are discussed. The dominant influence on side force, for most cars, however, is shown to be the vehicle height which is consistent with slender wing theory if the car and its mirror image are considered. This simple theory is shown to apply to 1-box and 2- box shapes, covering most MPVs, hatchbacks and SUVs, but does not adequately represent the side forces on notchback and fastback car shapes. Data from simple bodies is used to develop a modification to the basic theory, which is applied to these vehicle types.

The aerodynamic development of cars is conventionally carried out in the wind tunnel with the working section floor representing the ground surface. While recognising that the boundary conditions are false it has generally been assumed that this basic ground simulation is adequate for road cars. This situation is currently being reappraised. In this investigation a simple 1/4 scale car model has been tested in the MIRA Model Wind Tunnel, using both moving and stationary belt to represent the ground surface. The body and wheel drag contributions were measured independently. The influence of rear body shape, front spoilers, cooling airflow, and underfloor roughness on the aerodynamic characteristics, for both ground conditions has been assessed.

Door mirrors have a small but measurable contribution to the overall aerodynamic drag of a road vehicle. Typically for passenger cars and SUVs this is in the range 2.5–5%. It can be difficult to refine the shape of door mirrors as the improvements are, sometimes, too small to measure with any accuracy. A test rig has been developed which allows a full size door mirror to be tested in a model wind tunnel facility, which has better balance resolution, where the mirror is mounted to a partial vehicle body. This also results in a faster and cheaper method to develop shapes for door mirrors. The rig is described and the initial correlation tests presented. The limitations of the rig and some further applications are discussed.