This method of gaging alignment of nut slots allows equal variations for location of the cotter pin hole in the bolt and location of slots in the nut. To inspect the nut, the slotted gage is inserted through the nut hole from the bearing surface of the nut. Alignment of slots is considered satisfactory if the gage pin can be slipped into the gage and nut slots without interference.
Round head bolts are made in two body styles: (a) A full size body, with a maximum diameter somewhat greater than the nominal diameter (not an SAE Standard except for ribbed neck bolts, Table 3); and (b) an undersize body, with a minimum diameter approximating the pitch diameter of the thread and a maximum diameter never exceeding nominal (SAE standard for all types except ribbed neck bolts). The body diameter of either style may be exceeded by a reasonable swelling or fin under the head, or under corners of the square necks, to the extent that serviceability is not affected.
This specification describes the general connectors, contacts, and backshells in their shape and characteristic for cabin systems for commercial aircrafts. ARINC 600, ARINC 404, and ARINC 801 connector specifications are published as independent standards.
This specification describes the general connectors, contacts, and backshells in their shape and characteristic for cabin systems for commercial aircrafts. ARINC 600, ARINC 404, and ARINC 801 connector specifications are published as independent standards.
AS9131 - This standard defines the common nonconformance data definition and documentation that an internal or external supplier or sub-tier supplier must submit when informing a customer of a nonconformity. The requirements shall be are applicable for reporting a nonconforming product to the owner/operator (i.e., end item user), if specified by contract. Reporting of nonconformance data, either electronically or conventionally on paper, is subject to the terms and conditions of the contract. This also includes, where applicable, data access under export control regulations.
The purpose of this standard is to provide a source of definitions of terms and acronyms commonly used in the air transport maintenance community for test and evaluation with an emphasis on terms applicable to BITE.