Refine Your Search

Topic

Author

Affiliation

Search Results

Standard

Bumper Jack Requirements--Motor Vehicles

1967-01-01
HISTORICAL
J979_196701
The following requirements and test information can be used to obtain reasonable quality and uniformity for bumper jacks. For this specification, a fully loaded vehicle includes curb weight, optional equipment, weight at 150 lb each for specified number of passengers, and a 150 lb load in the trunk. Vehicles with a gvw rating will be loaded to the maximum specified gvw.
Standard

Ship Systems and Equipment--Part Standard for Studs--Continuous and Double End (Inch Series)

2009-01-23
HISTORICAL
J2271_200901
This SAE Parts Standard provides dimensional and quality assurance requirements for studs in the following configurations in standard materials used for ship system applications: a. Continuous thread studs in UNRC and 8UNR series in the following threads and diameters: - UNRC threads (0.190 through 4 inches) - UNRF threads (0.190 through 1-1/2 inches) - 8UNR threads (1-1/8 through 4 inches) b. Double end studs (clamping type) where both ends are of the same thread length in the following threads and diameters: - UNRC threads (1/4 through 4 inches) - UNRF threads (1/4 through 1-1/2 inches) - 8UNR threads (1-1/8 through 4 inches) c.
Standard

Ship Systems and Equipment - Part Standard for Studs - Continuous and Double End (Inch Series)

2004-06-21
HISTORICAL
J2271_200406
This SAE Parts Standard provides dimensional and quality assurance requirements for 1/4 through 2 in sizes of studs in the following configurations in standard materials used for ship system applications: a. Continuous thread studs in UNRC and 8UNR series. b. Double end studs (clamping type) where both ends are of the same thread series (UNRC or 8UN). Also called bolt-studs. (These are suitable for mating with nuts or the set end may be installed with anaerobic thread locking compound.) c. Double end studs (interference thread type) with the nut end having UNRC or 8UNR series thread and where the tap end has NC 5 HFS interference fit thread forms. Also called a tap end stud. A complete metric companion to this document is provided in SAE J2271M, therefore no metric equivalents are presented. These studs are primarily or use in ship systems and equipment.
Standard

Torque Ratings for Power Take-off Mounting Pads

2003-07-25
HISTORICAL
J2662_200307
This SAE Recommended Practice is intended to serve as a reference for the amount of torque that a Power Take-Off can induce on the transmission mounting pad. This document will apply to six-bolt, eight-bolt, and rear mounted power take-offs.
Book

Counterfeit Electronic Parts and Their Impact on Supply Chains

2014-10-20
Electronic parts are used throughout industry to run everyday products, such as cell phones, and also highly technical products, such as aircraft, missiles, and spacecraft. Unlike cell phones, which are often replaced every year, the highly technical products may remain in service from 20 to more than 80 years. But what happens if the original electronic part, with a life cycle of 18 months, is no longer available? Some manufacturers have discovered that they have unwittingly purchased counterfeit ones. Counterfeit Electronic Parts and Their Impact on Supply Chains examines how these items are negatively affecting the aviation, spacecraft, and defense sectors and what can be done about it.
Standard

TOOL AND DIE STEELS

1970-05-01
HISTORICAL
J438_197005
This standard covers the identification, classification, and chemical composition of tool and die steels for use by engineers, metallurgists, tool designers, tool room supervisors, heat treaters, and tool makers.
X