Search Results

An extensive investigation was conducted to assess the influence of steel sheet surface finish (i.e. topography or “texture”) on painted surface appearance. Ten sets of steel panels representing a variety of shot blast, EDT, laser, and bright surface textures were painted simultaneously using advanced solvent-based luxury vehicle paint systems. Paint appearance was measured using a relatively new Autospect instrument and also in terms of conventional Distinctness of Reflected Image (DOI). The results are discussed in detail with respect to 1) the influence of different steel surface textures on paint appearance, 2) the evolution of surface topography during painting, and 3) the implications of this work.

In-cylinder flows in four-valve SI engines were examined by high frame rate flow visualization and two-component LDV measurement. It is believed that the tumble and swirl motion generated during intake breaks down into small-scale turbulence later in the cycle. The exact nature of this relationship is not well known. However, control of the turbulence offers control of the combustion process. To develop a better physical understanding of the in-cylinder flow, the effects of the cylinder head intake port configuration and the piston geometry were examined. For the present study, a 3.5L, four-valve engine was modified to be mounted on an AVL single cylinder research engine type 520. A quartz cylinder was fabricated for optical access to the in-cylinder flow. Piston rings were replaced by Rulon-LD rings. A Rulon-LD ring is advantageous for the optical access as it requires no lubrication.

THIS STUDY WAS DEVELOPED in response to a component fatigue strength test which determined that if the current #3 engine bearing cap were used in the 2.5L Turbo application, it would be over stressed. Proposed solutions for solving this problem included: a redesigned grey iron cap with additional material in the highly stressed areas, or a cap made from either nodular iron or a free machining steel using current specifications. One of the manufacturing concerns about switching materials is the perceived difference in the machinability of nodular iron and steel. A single point turning evaluation was carried out by Chrysler Motors' Machinability Development Laboratory to compare the machinability of various materials proposed for use in engine bearing caps. Materials tested included: SAE G2500 grey cast iron, the current production material; SAE D45-12 nodular cast iron; and SAE steel grades 1117, 1137, 1215, 12L14, 1215, and 1215 modified (Incut 200).

Material properties of niobium (Nb)-treated SAE I 141 steel connecting rod produced by control cooling were evaluated in comparison with quenched and tempered connecting rod of the same steel. The microstructure of the control cooled connecting rod is predominantly bainitic compared with tempered martensite for the quenched and tempered rod. Tensile strengths are comparable, while yield strength and ductility are lower for the control cooled connecting rod. There are small variations in hardness of the control cooled connecting rod depending on the section thickness in contrast with the uniform hardness for the quenched and tempered rod. Component high-cycle fatigue resistance is lower for the control cooled connecting rod due to the lower yield strength. Both connecting rods meet the fatigue strength performance requirements for the rod design evaluated.