Search Results

This paper presents a new substrate for Lean NOx Traps (LNT) which enables high NOx conversion efficiency, even after long-term aging, when using alkali metals as the NOx adsorber. When a conventional metal honeycomb is used as the LNT substrate, the chromium in the metal substrate migrates into the washcoat and reacts with the alkali metals after thermal aging. In order to help prevent this migration, we have developed a new substrate where a fine -alumina barrier is precipitated to the surface of the metal substrate. The new substrate is highly capable of preventing migration of chromium into the washcoat and greatly enhances the NOx conversion. The durability of the new substrate and emission test using a test vehicle are also examined.

Friction Stir Spot Welding (FSSW) is an emerging joining technique that has seen some successful automotive applications in the past few years. One of the most significant factors that influence the joint strength of a friction stir spot weld is the tool geometry. The tool geometry used in FSSW has been traditionally derived from friction stir linear welding and there has not been much focus on developing tool geometries specifically for FSSW. The main objective of this paper is to evaluate different pin geometries that are specifically catered towards maximizing the strength of friction stir spot welds. In order to evaluate the effect of only the pin, all tools considered had flat shoulders. Four different pin shapes were evaluated - baseline, thick, tapered and inverse tapered pins. Three different pin lengths were considered for each pin shape - 1.0, 1.2 and 1.4mm.

Lightweight metals such as Al and Mg alloys have been increasingly used for reducing mass in both structural and non-structural applications in transportation industries. Joining these lightweight materials using traditional fusion welding techniques is a critical challenge for achieving optimum mechanical performance, due to degradation of the constituent materials properties during the process. Friction stir welding (FSW), a solid-state joining technique, has emerged as a promising method for joining these lightweight materials. In particular, high joining efficiency has been achieved for FSW of various Al alloys and Mg alloys separately. Recent work on FSW of dissimilar lightweight materials also show encouraging results based on quasi-static shear performance. However, coach-peel performance of such joints has not been sufficiently examined.

The recovery of important minerals, salt (NaCI) and potassium (K), in a closed system, namely CELSS is discussed. NaCI is needed for humans, but is potentially harmful to plants. Salt is recovered after wet oxidation of urine. Since Na and K have similar chemical and physical properties, their recovery or separation may require sophisticated methods. Na, CI and K ions are separated from other ions by electrodialysis with univalent selective ion-exchange membranes and then NaCI is obtained separately by a crystalization process. Preliminary experiment on crystalization of NaCI-KCl mixed solutions showed a good separation result.

A numerical simulation technique was implemented to automatically optimize the plunger velocity to reduce the defects occurring during die-casting by considering the number of free surfaces and potential energy of the molten metal. In pressure die-casting, the most common defect is porosity that is formed by air entrapment in the following two stages - the first is the injection of the molten metal into shot sleeve, and the second is the filling of the molten metal into the cavity. The latter phenomenon has been investigated in detail by various numerical simulation codes, but there is limited information concerning the former. In order to the simulate flow pattern in the shot sleeve, a moving boundary method is incorporated into the conventional filling simulation system. In addition, the plunger speed and the acceleration time for the various pre-filled levels of molten metal in the sleeve are determined by automatic optimization.