Search Results

Power steering systems provide significant design challenges. They are detrimental to fuel economy since most require the continuous operation of a hydraulic pump. This generates heat that must be dissipated by fluid lines and heat exchangers. This paper presents a simple one-dimensional transient model for power steering components. The model accounts for the pump power, heat dissipation from fluid lines, the power steering cooler, and the influence of radiation heat from exhaust system components. The paper also shows how to use a transient thermal model of the entire system to simulate the temperatures during cyclic operation of the system. The implications to design, drive cycle simulation, and selection of components are highlighted.

Mobile source emissions standards are becoming more stringent and particulate emissions from gasoline direct injection (GDI) engines represent a particular challenge. Gasoline particulate filter (GPF) is deemed as one possible technical solution for particulate emissions reduction. In this work, a study was conducted on eight formulations of lubricants to determine their effect on GDI engine particulate emissions and GPF performance. Accelerated ash loading tests were conducted on a 2.4L GDI engine with engine oil injection in gasoline fuel by 2%. The matrix of eight formulations was designed with changing levels of sulfated ash (SASH) level, Zinc dialkyldithiophosphates (ZDDP) level and detergent type. Comprehensive evaluations of particulates included mass, number, size distribution, composition, morphology and soot oxidation properties. GPF performance was assessed through filtration efficiency, back pressure and morphology.

An engine test has been developed to assess the impact of volatile phosphorus from passenger car engine oils on catalytic converter efficiency. The ten-day, steady-state, catalyst aging test was established to promote the production and consumption of volatile phosphorus species contained in crankcase vapors that are evacuated and combusted via the PCV system. A system for sampling, analyzing and identifying crankcase vapors led to a greater understanding of the phosphorus-based poisoning mechanism. Catalytic converter conversion efficiency was assessed through an engine-based system that swept catalyst inlet temperature from low to high while using a constant flow of controlled exhaust gas. The test results indicate correct ranking of field-tested oils that have catalyst poisoning data.

Since the introduction of the catalytic converter, some automobile manufacturers have questioned whether the converter is compatible with the use of the gasoline fuel additive MMT®. Concerns have generally revolved around possible interactions between combustion products of MMT® (i.e., manganese containing compounds) and catalytic converters. In particular, concern has been raised over the possibility that MMT® combustion products physically “plug” the catalyst and cause catalyst failure, where plugging refers to blockage of contiguous pores at the catalyst inlet face or within the body of the converter. In modern vehicles this could result in the illumination of the malfunction indicator light (MIL) due to storing of an on-board diagnostic (OBD) failure code pertaining to catalyst operation or failure of a vehicle inspection and maintenance (I/M) test.