Refine Your Search

Search Results

Viewing 1 to 8 of 8
Standard

Use of HVOF Thermal Spray Coatings for Hard Chrome Replacement in Landing Gear Applications

2007-02-22
CURRENT
ARP5935
Electrolytically deposited chrome plate is the current standard surface treatment for landing gear component interface surfaces that require good wear resistance and corrosion protection. Chrome plated components are typically plagued by a slight debit in fatigue performance, detrimental mud cracking surface pattern, susceptibility to scoring, wear, and seal leakage. In addition, recent changes in environmental compliance standards place further restrictions on the use of electrolytically deposited chromium. Some commercial applications have already eliminated the use of chrome plate on current and future products. As a result, a substitute for electrolytically deposited chrome plate has been sought for several years. High Velocity Oxygenated Fuel (HVOF) thermal spray coatings have been developed to the point where they are being implemented as an alternative to hard chrome plate on high strength low alloy steels for external surfaces on landing gear applications.
Standard

Inflator Assembly and Gage Elements, Pneumatic Pressure, Remote Control, Direct Reading

2002-02-13
HISTORICAL
AS85352
This specification covers a direct reading, remote control, pneumatic pressure inflator assembly, for use on aircraft tires and struts having pneumatic pressure requirements up to 600 psi. It includes pressure relief provisions to provide for safe inflation. Also included are dual chuck stem gages for measuring tire pressure.
Standard

Inflator Assembly and Gage Elements, Pneumatic Pressure, Remote Control, Direct Reading

2018-04-09
CURRENT
AS85352A
This specification covers a direct reading, remote control, pneumatic pressure inflator assembly, for use on aircraft tires and struts having pneumatic pressure requirements up to 600 psi. It includes pressure relief provisions to provide for safe inflation. Also included are dual chuck stem gages for measuring tire pressure.
Standard

GLAND DESIGN: SCRAPER, LANDING GEAR, INSTALLATION

1994-04-01
HISTORICAL
AS4052
This SAE Aerospace Standard (AS) covers an alternate gland design for the installation of scraper/wiper rings in the lower end of landing gear shock struts for the purpose of contaminant exclusion. The defined scraper gland covered by this document, as shown in Table 1, is a variant of MIL-G-5514, the accepted gland standard for MS28775. Piston diameters, gland internal diameters, and the groove sidewall angles and surface finish are defined by MIL-G-5514, but the gland outer retaining wall diameter is changed. AS4088 is similar to this document, but was developed by SAE A-6 for flight control and general purpose cylinders. It differs from this document primarily by the clearance between the rod (piston) and outer gland wall. Since landing gears are more susceptible to dirt contamination, the additional clearance provides a larger path to allow excessive dirt accumulation to exit the gland.
X