Refine Your Search

Search Results

Viewing 1 to 13 of 13
Standard

Cutting Edge - Cross Sections Loader Straight with Bolt Holes

2011-10-25
CURRENT
J1304_201110
For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge—Cross Sections Loader Straight," SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters. NOTE—For some heavy-duty applications, cross sections with larger blunts, greater bevel angles, and larger bolt holes may be required.
Standard

Rated Operating Load for Loaders Equipped with Log or Material Forks Without Vertical Mast

2011-10-27
CURRENT
J1197_201110
This SAE Recommended Practice applies to wheel and crawler loaders when equipped with log or material handling forks without vertical masts, taking only hydraulic lift capacity and operating stability into consideration. It is recognized that specific operating conditions may allow larger, or require smaller loads than the rated operating load. Some conditions would require more careful or restricted operation with the rated operating load. This practice is not to be construed as setting up test procedures or conditions.
Standard

Cutting Edge - Double Bevel Cross Sections

2019-04-22
WIP
J738
This standard is for cutting edge sections typically used in earth-moving machinery defined in SAE J1116 and ISO 6165: a. Scrapers as defined in ISO 7133. b. Dozers as described in ISO 6747. c. Loaders as described in ISO 7131. d. Graders as described in ISO 7134. Hole spacing is defined ISO 7129. Hole conformation is defined in SAE J740.
Standard

Cutting Edge - Double Bevel Cross Sections

2014-01-08
CURRENT
J738_201401
This standard is for cutting edge sections typically used in earth-moving machinery defined in SAE J1116 and ISO 6165: a Scrapers as defined in ISO 7133. b Dozers as described in ISO 6747. c Loaders as described in ISO 7131. d Graders as described in ISO 7134. Hole spacing is defined ISO 7129. Hole conformation is defined in SAE J740.
X