Refine Your Search

Date

Date

Topic

Topic

Ferrous metals Standard Humidity Exhaust emissions ACBG Plain Bearing Committee Manufacturing processes Fuel injection Electronic control systems Electrical, Electronics, and Avionics

Search Results

Viewing 1 to 20 of 87
123Next >Last >>
Sort by relevance
Standard

Bearings, Plain, Self-Aligning, Self-Lubricating, 300 cpm Oscillation (13 fpm), -65 to +160 °F (-54 to +71 °C), Liners Less Than 0.015 inches
2018-08-23
CURRENT
AS82819
This standard covers the requirements for spherical, self-aligning, self-lubricating, bearings which are for use in the ambient temperature range of -65 to +160 °F (-54 to +71 °C) at high cyclic speeds 300 cpm (13 fpm) for liners with a thickness less than 0.015 inch. The scope of this standard is to provide a liner system qualification procedure for helicopter sliding bearings defined and controlled by source control drawings. Once a liner system is qualified, the source-controlled bearings are further tested under application conditions. Under Department of Defense (DoD) Policies and Procedures, any qualification requirements and associated Qualified Products List (QPLs) are mandatory for DoD contracts. Any materials relating to QPLs have not been adopted by SAE and are not part of this SAE technical document.
Standard

Bearings, Elastomeric General Specification for
2021-02-11
CURRENT
AS85598
This standard defines general requirements for spherical, radial-journal, conical, and thrust bearings which are of laminated elastomeric construction. These bearings are for use in an environment having a temperature spectrum of -65 to +160 °F while reacting steady state loads in addition to oscillating loads and motions. The operating temperature range of -65 to +160 °F reflects the current temperature range for existing parts, but allows for expansion in the future.
Standard

Plain Bearing Lined Inside Diameter Plug Gaging
2001-03-01
HISTORICAL
ARP5448/9
This test method establishes a standard procedure for using plug gages to evaluate dimensional conformance of lined inside diameters of bearings. Bearings covered by this test method include sleeve bearings and lined bore spherical bearings. Note that this method gives no indication of true cylindricity.
Standard

Plain Bearing Lined Inside Diameter Plug Gaging
2019-05-23
CURRENT
ARP5448/9B
This test method establishes a standard procedure for using plug gages to evaluate dimensional conformance of lined inside diameters of bearings. Bearings covered by this test method include sleeve bearings and lined bore spherical bearings. Note that this method gives no indication of true cylindricity.
Standard

Plain Bearing Lined Inside Diameter Plug Gaging
2012-09-26
HISTORICAL
ARP5448/9A
This test method establishes a standard procedure for using plug gages to evaluate dimensional conformance of lined inside diameters of bearings. Bearings covered by this test method include sleeve bearings and lined bore spherical bearings. Note that this method gives no indication of true cylindricity.
Standard

Rod End Locking Device Selection Criteria
2020-07-01
CURRENT
ARP6910
This ARP discusses common rod end locking devices with recommended applications and some of the advantages and disadvantages of specific configurations. An appendix is included with factors to be considered for selection of positive locking devices and a discussion of safetying devices for rod end assemblies.
123Next >Last >>
X