Refine Your Search

Topic

Author

Affiliation

Search Results

Standard

Air Dryer Test Procedure

2012-11-09
CURRENT
J2384_201211
This SAE Recommended Practice establishes uniform Test Procedures for desiccant Air Dryers used in vehicles with compressed air systems per SAE J2383. Continuous flow desiccant Air Dryers are excluded from the scope of this document.
Standard

Fuel Injection Equipment Nomenclature

1999-04-21
HISTORICAL
J830_199904
This SAE Standard establishes a vocabulary and definitions relating to the components used in fuel injection systems for compression ignition (diesel) engines. Definitions are separated into six sections by topic as follows: Section 3— Fuel Injection Pumps Section 4— Fuel Injectors Section 5— Unit Injectors Section 6— Governors Section 7— Timing Devices Section 8— High Pressure Pipes and Connections NOTE— When the word "fuel" is used in the terms listed it may be omitted providing there can be no misunderstanding.
Standard

Engine Terminology and Nomenclature - General

2011-08-05
CURRENT
J604_201108
This SAE Recommended Practice is applicable to all types of reciprocating engines including two-stroke cycle and free piston engines, and was prepared to facilitate clear understanding and promote uniformity in nomenclature. Modifying adjectives in some cases were omitted for simplicity. However, it is good practice to use adjectives when they add to clarity and understanding.
Standard

Automatic Transmission Hydraulic Control Systems - Terminology

2011-06-13
CURRENT
J648_201106
The following is a list of the most common terminology used in describing hydraulic control systems. The hydraulic control system of an automatic transmission may include oil pumps, pressure regulator, governor, and control valves.
Standard

Qualifications for Four-Way Subbase Mounted Air Valves for Automotive Manufacturing Applications

2005-05-25
CURRENT
J2051_200505
This SAE Recommended Practice describes the requirements necessary for four-way subbase mounted, directional air-control valves to be used in automotive manufacturing applications. It includes minimum performance, operation, and physical requirements to qualify the valves for service in automotive manufacturing applications. Included are spool, poppet, and sliding disc types of air valves for pressures in a range of vacuum to 1034 kPa (150 lb/in2) gage, and temperatures from −18 to 60 °C (0 to 140 °F).
Standard

Qualifications for Four-Way Subbase Mounted Air Valves for Automotive Manufacturing Applications

1992-06-01
HISTORICAL
J2051_199206
This SAE Recommended Practice describes the requirements necessary for four-way subbase mounted, directional air-control valves to be used in automotive manufacturing applications. It includes minimum performance, operation, and physical requirements to qualify the valves for service in automotive manufacturing applications. Included are spool, poppet, and sliding disc types of air valves for pressures in a range of vacuum to 1034 Kpa (150 lb/in2) gage, and temperatures from -18 to 60 °C (0 to 140 °F).
Standard

Hydraulic Directional Control Valves, 3000 PSI Maximum

2014-10-24
CURRENT
J748_201410
This SAE Recommended Practice has been set up by Subcommittee 4 of the Off-Road Machinery Technical Committee and is primarily for directional control valves on construction and industrial machinery equipment as referenced in SAE J1116. The purpose is to establish port area to flow relationship and match valve spool eye ends in relation to rated capacity. Port connections are optional for either the 4-bolt split flange connection or the internal straight thread "O" ring connection.
X