Refine Your Search

Search Results

Viewing 1 to 3 of 3
Technical Paper

High Strain-Rate Tensile Testing of Door Trim Materials

Abstract The objective of this study was to determine dynamic tensile characteristics of various door trim materials and to recommend a practical test methodology. In this study, Polypropylene (PP) and Acrilonitryl Butadiene Styrene (ABS) door trim materials were tested. Slow speed (quasi-static-0.021 mm/s) and high speed tests were conducted on a closed loop servo-hydraulic MTS system. The maximum stress of these materials increased from quasi-static to dynamic test conditions (as much as 100%). The dynamic stiffness of PP increased two times from quasi-static tests. No significant change in stiffness was observed for ABS during quasi-static and dynamic tests at different strain-rates. Quasi-static and medium strain-rate (10-20 mm/mm/s) tests may be adequate in providing data for characterizing the dynamic behavior of trim materials for CAE applications. Strain gages can be used to measure the quasi-static and in some cases, dynamic strain.
Technical Paper

Simulation of Outer Door Handle and Latch Responses in Side Impact using Component Test Methodology

A dynamic component test methodology using a door sub-system was developed to simulate the outside door handle/latch responses (accelerations and deformations) as in a full-vehicle NHTSA FMVSS 214 side impact test. The test methodology consists of a door sub-system (with door inner components) which is allowed to pivot by means of a hinge at the top of the door. The lateral structural load path affecting the door/rocker response was accounted and simulated (obtained from full-vehicle FE analysis) in this methodology by means of an energy absorbing material (Aluminum honeycomb) of predetermined stiffness. A bullet sled simulating the Moving Deformable Barrier (MDB) surface and stiffness at the same relative location to the door/rocker (as in full-vehicle test) strikes the stationary hinged door at an initial velocity of approx. 30 mph (longitudinal component of crab cart velocity of 33.5 mph).
Technical Paper

A New Component Test Methodology Concept for Side Impact Simulation

This paper describes the development of a new component test methodology concept for simulating NHTSA side impact, to evaluate the performance of door subsystems, trim panels and possible safety countermeasures (foam padding, side airbags, etc.). The concept was developed using MADYMO software and the model was validated with a DOT-SID dummy. Moreover, this method is not restricted to NHTSA side impact, but can be also be used for simulating the European procedure, with some modifications. This method uses a combination of HYGE and VIA decelerator to achieve the desired door velocity profile from onset of crash event until door-dummy separation, and also takes into account the various other factors such as the door/B pillar-dummy contact velocity, door compliance, shape of intruding side structure, seat-to-door interaction and initial door-dummy distance.