This SAE Standard specifies a procedure for approximating the volume of a typical material carried in the bowl of an elevating scraper as defined in SAE J728 and SAE J1057. The volumes are based on the inside dimensions of the bowl and a representative volume on top of the bowl. This rating method is intended to provide a consistent means of comparing capacities; it is not intended to define actual capacities that might be observed in any specific application.
This standard applies to machines which are designed to raise, lower, and carry pipe and loads of similar nature. The term pipelayer does not include tractors or loaders with side booms which are optional attachments, manufacturer or dealer-installed, to machines as defined in SAE J1057. Note: Some related standards will apply equally to pipelayers and to tractors and loaders with side boom. Two such standards are SAE J743 and ANSI B30.14.
This SAE Standard describes a uniform method to calculate and specify travel performance characteristics of hydraulic excavators, material handlers, knuckle boom log loaders, delimbers, feller bunchers, harvesters, processors, and other knuckle boom material handlers. It establishes definitions and specifies machine conditions for calculations and tests. This document applies to crawler mounted machines such as hydraulic excavators as defined in SAE J/ISO 6165 and ISO 7135, and knuckle boom log loaders as defined in SAE J1209 and SAE J2055. This document also applies to certain forestry equipment defined in SAE J1209 and ISO 6814 that have crawler mountings such as delimbers, feller bunchers, harvesters, and processors. Included in the definition of hydraulic excavators are also front shovel, clamshell, and telescoping boom excavators.
This standard covers off-road, self-propelled work machines (agricultural, construction, forestry, industrial, and mining) as categorized in SAE J1116.
This standard covers off-road, self-propelled work machines (agricultural, construction, forestry, industrial, and mining) as categorized in SAE J1116.
This recommended practice covers off-road, self-propelled work machines (agricultural, construction, forestry, industrial, and mining) as categorized in SAE J1116 (May 1979).
This SAE Information Report applies to all independent or combination construction and industrial machines that are designed to scraper-load and transport material. (See SAE J1116 and J1057a.)
This SAE Standard establishes a test method to measure drag force of self-propelled, as well as towed, construction, forestry, and industrial machines, with or without payload, as listed in SAE J/ISO 6165 and J1116. Drag force is measured as a function of travel speed.
This SAE Standard provides a uniform method to calculate the lift capacity of scrap and material handlers, establishes definitions and specifies machine conditions for the calculations. This document applies to scrap and material handlers as defined in SAE J2506 that have a 360 degrees continuous rotating upper structure. It does not apply to equipment that is incapable of lifting a load completely off the ground. This document applies to those machines that are crawler, wheel, rail and pedestal or stationary mounted.
This SAE Standard sets forth standard dimension requirements for the loader attachment bracket and attachment interface to allow interchangeability of attachments on skid steer loaders whose operating mass (see SAE J/ISO 6165) is 4,500 kg or less. Narrow skid steer loaders may have a width that does not allow compliance with this standard. The design of the loader attachment bracket locking system is not restricted by this standard and is left to the discretion of the manufacturer.
This standard applies to hydraulic backhoes which have no more than 190 degrees of rotational swing and are mounted on wheeled tractors and crawler tractors.