Search Results

Misfiring of the engine can cause damage to the catalyst within short time and increase emissions. Under misfiring conditions, unburned fuel and oxygen are pumped into the catalyst, where its combustion heavily increases the temperature. For this reason there is a demand for fast detection of misfiring. Once judged, one can take countermeasures to avoid further temperature rise. Two methods of misfire detection with the prospect of future use in series production are discussed. A first approach uses the trace shape of the λ-sensor signal for evaluation. The second approach uses the speed fluctuations of the engine for detection. Efficient algorithms give the possibility of misfire detection in the full load-speed range with reasonable effort to protect the catalyst. However there will remain some misfire conditions, increasing the emissions above regulation limits, that cannot be detected by those methods.

Meeting current exhaust emission standards requires rapid catalyst light-off. Closed-coupled catalysts are commonly used to reduce light-off time by minimizing exhaust heat loss between the engine and catalyst. However, this exhaust gas system design leads to a coupling of catalyst heating and engine operation. An engine-independent exhaust gas aftertreatment can be realized by combining a burner heated catalyst system (BHC) with an underfloor catalyst located far away from the engine. This paper describes some basic characteristics of such a BHC system and the results of fitting this system into a Volkswagen Touareg where a single catalyst was located about 1.8 m downstream of the engine. Nevertheless, it was possible to reach about 50% of the current European emission standard EU 4 without additional fuel consumption caused by the BHC system.

An effective method for detecting misfire using crank speed fluctuations has been developed for on-board use in production vehicles. Engine misfire is represented in this method by Engine Roughness identified by crankshaft rotational acceleration. Engine Roughness is calculated for each combustion event and is compared with a speed and load dependent threshold permitting the determination of single or continuous misfire. Correctional functions are applied to avoid erroneous detection during highly transient engine operation. In the wide range of engine speed and load at common driving conditions the detection of single and continuous misfire events is possible without requiring additional sensors or electronic hardware in most cases. This sophisticated method as well as other OBDII functions has already been implemented into 8 bit and 16 bit ECU's.