Refine Your Search

Search Results

Viewing 1 to 5 of 5
Standard

Selection of Zinc and Zinc-Alloy (Hot-Dipped and Electrodeposited) Coated Steel Sheet

2009-01-13
HISTORICAL
J1562_200901
Zinc and zinc-alloy coated steel is used to enhance a structure’s protection against corrosion degradation. For the purpose of this SAE Recommended Practice, a galvanized coating is defined as a zinc or zinc-alloy metallic coating. The selection of the optimum galvanized steel sheet product depends on many factors, the most important being: desired corrosion protection, formability, weldability, surface characteristics, and paintability. The trade-offs of these product characteristics are more complex than is the case with uncoated steel sheet products.
Standard

CATEGORIZATION AND PROPERTIES OF LOW-CARBON AUTOMOTIVE SHEET STEELS

1997-05-01
HISTORICAL
J2329_199705
This SAE Recommended Practice establishes mechanical property ranges for low-carbon automotive hot-rolled sheet, cold-rolled sheet, and metallic-coated sheet steels. It also contains information that explains the different nomenclature used with these steels.
Standard

Categorization and Properties of Dent Resistant, High Strength, and Ultra High Strength Automotive Sheet Steel

1999-10-25
HISTORICAL
J2340_199910
This SAE Recommended Practice defines and establishes mechanical property ranges for seven grades of continuously cast high strength automotive sheet steels that can be formed, welded, assembled, and painted in automotive manufacturing processes. The grade of steel specified for an identified part should be based on part requirements (configuration and strength) as well as formability. Material selection should also take into consideration the amount of strain induced by forming and the impact strain has on the strength achieved in the finished part. These steels can be specified as hot-rolled sheet, cold-reduced sheet, uncoated, or coated by hot dipping, electroplating, or vapor deposition of zinc, aluminum, and organic compounds normally applied by coil coating. The grades and strength levels are achieved through chemical composition and special processing. Not all combinations of strength and coating types may be commercially available. Consult your steel supplier for details.
Standard

Standardized Dent Resistance Test Procedure

2004-06-07
HISTORICAL
J2575_200406
These test procedures were developed based upon the knowledge that steel panel dent resistance characteristics are strain rate dependent. The “quasi-static” section of the procedure simulates real world dent phenomena that occur at low indenter velocities such as palm-printing, elbow marks, plant handling, etc. The indenter velocity specified in this section of the procedure is set to minimize material strain rate effects. The dynamic section of the procedure simulates loading conditions that occur at higher indenter velocities, such as hail impact, shopping carts, and door-to-door parking lot impact. Three dent test schedules are addressed in this procedure. Schedule A is for use with a specified laboratory prepared (generic) panel, Schedule B is for use with a formed automotive outer body panel or assembly, and Schedule C addresses end product or full vehicle testing.
X