Search Results

Diesel fuels have been tested in both a naturally aspirated and an externally supercharged single cylinder, air cooled KHD DI-diesel engine, to determine the influence of poor fuel quality on combustion and emissions. A thermodynamic analysis of the cylinder pressure was conducted and the emissions were measured both gaseous as well as the particle emission (by means of a dilution tunnel). Additionally, extensive cold start tests were conducted. Under steady state conditions the cetane number seems to be a good parameter which describes the ignition behavior of different fuels. At low load, a change in combustion and a high increase in CO, HC and particle emissions were found with decreasing cetane number. During cold starting and warming up, a clear deterioration of the emission and combustion characteristics was also observed with decreasing cetane number when basic fuels were used.

A vehicle investigation programme was initiated to evaluate the influence of diesel fuel sulfur content on the performance of a DeNOx catalyst for NOx control. The programme was conducted with a passive DeNOx catalyst, selected for its good NOx reduction performance and two specially prepared fuels with different sulfur contents. Regulated emissions were measured and analysed during the course of the programme. The NOx conversion efficiency of the DeNOx catalyst increased from 14 to 26% over the new European test cycle when the sulfur content of the diesel fuel was reduced from 49 to 6 wt.-ppm. In addition the number and size of particles produced using 6 wt.-ppm sulfur fuel were measured by two different techniques: mobility diameter by SMPS and aerodynamic diameter by impactor. The influence of the assumed density of the particulate on the apparent diameters measured by the two techniques is discussed.