The purpose of this SCR filter test method is to provide standardized methods for evaluation the filter characteristics of the SCR filter by bench test methods. This, combined with data obtained from application test, maybe used to establish standards of performance for filters when tested by these standard methods. Many variation in requirements of filtration to protect the SCR supply equipment on vehicles and variations in operational conditions make it difficult to specify meaningful “in-service” performance standards by which a filter may be judged. By the use of these standard test methods, test conditions are always the same, and comparison of the laboratory performance of filters may be made with a high degree of confidence. Once the requirement of a particular application are known, performance standards for suitable filters may be established by these test methods, and adequacy of performance of filters for the job may be determined.
The scope of this document is to provide a guidance of the common contamination types and their concentrations in order to size FTIS components and characterize its performance on generic commercial aircraft.
Aircraft-mounted Closed Circuit Refueling receiver adapter – Definition of standard interface dimensions for adapter which interfaces with MIL-PRF-52747F Nozzle.
This SAE Aerospace Recommended Practice (ARP) provides guidance for the verification and certification of a “commercial” fixed wing aircraft fuel tank inerting system (FTIS) and will provide technical references and data regarding ground and flight testing of an FTIS. The intent of this ARP is to address issues associated with the verification requirements based on current regulatory guidance per AC25.981-2C
The document provides a definition of skew and disconnect occuring in high lift systems in flight controls including their hazard assessment, describes generic solutions and provides a for specifying requirements.
Scope: This Aerospace Recommended Practice (ARP) provides guidelines for specifying dielectric withstanding strength and insulation resistance design and test requirements for aircraft line replaceable units (LRU's) used within a flight control and/or a utility system. 1.1 Purpose The testing is intended to verify that an LRU can operate safely at its rated voltage and withstand momentary over potentials due to switching, troubleshooting testing, surges, etc.. The testing is also intended to verify adequate design margin of the insulation system and detect workmanship problems.
This Aerospace Recommended Practice (ARP) offers guidelines for specifying servoloop pressure feedback transducers for use in hydraulic actuation for servosystems.
To cover all forms of equipment used to inject/blend additive into the fuel flowing from the refueling equipment to the aircraft. For any additive, injected by any means. We plan 4 basic types of equipment from fully manual to fully automatic.
This Aerospace Recommended Practice (ARP) provides guidance on methods for system level pump ripple and pulsation testing. Covered are pump testing versus system pulsation testing, test conditions, instrumentation and data collection, data reduction and analysis, and resolution of issues identified during testing.
J3078/4 specifies a uniform test method for measuring the contribution to operator environmental temperature provided by a heating, ventilating and air conditioning system operating in a specific ambient environment. The method might not determine the complete climatic environment of the operator since this is also affected by heat load from sources other than those on the machine, for example solar heating. J3708/6 is to be used in conjunction with J3078/4 to determine more accurately the complete heat loading on the operator enclosure. Minimum performance levels for the machine’s operator enclosure heating, ventilating and air conditioning systems are established in J3708/4.
This SAE Standard specifies: a test method for assessing the lubricating property of diesel fuels including those which may contain a lubricity enhancing additive, and the performance criteria necessary to ensure reliable operation of diesel fuel injection equipment with respect to fuel lubrication of such equipment. It applies to fuel used in diesel engines.
This specification covers the general requirements for the design, installation, and performance of thermal anti-icing equipment for the wings and empennage surfaces in aircraft.