Search Results

Prior studies of the effect of gasoline composition and physical properties on automotive exhaust and evaporative emissions have been reviewed. The prior work shows that the parameters selected for investigation in the Auto/Oil Air Quality Improvement Research Program (AQIRP) - gasoline aromatics content, addition of oxygenated compounds, olefins content, 90% distillation temperature, Reid vapor pressure, and sulfur content - can affect emissions. Effects have been observed on the mass of hydrocarbon, CO, and NOx emissions; on the reactivity of emissions toward ozone formation; and on the emissions of designated toxic air pollutants. The individual effects of some of the AQIRP parameters have been studied extensively in modern vehicles, but the most comprehensive studies of gasoline composition were conducted in early 1970 vehicles, and comparing the various studies shows that fuel effects can vary among vehicles with different control technology.

Fuel effects on exhaust emissions of a sample of seven high emitting vehicles were studied. The vehicles had various mechanical problems and all ran fuel rich. The degree of enrichment varied between tests, and strongly affected mass emissions. Variable enrichment can cause incorrect apparent fuel effects to be calculated if not accounted for in data analysis. After variable enrichment was compensated for, the percentage effects of fuel oxygen, RVP, and olefins were largely in agreement with prior findings for normally emitting vehicles. Reducing fuel sulfur and T90 may have less benefit on hydrocarbon emissions in these high emitters than in normal emitters, and reducing sulfur may have less benefit on CO emissions. Reducing aromatics may be somewhat more helpful in reducing hydrocarbon and CO emissions in the high emitters.

Effects of gasoline sulfur content on emissions were measured in a fleet of ten 1989 model year vehicles. Two ranges of sulfur content were examined. In a set of five fuels, reducing sulfur from 450 to 50 ppm, reduced fleet average tailpipe emissions of HC, NMHC and CO each by about 18%, and reduced NOx 8%. The largest effect on HC and CO emissions was observed in FTP Bag 2. This and the absence of any significant effect on engine emissions indicate that sulfur affected the performance of the catalytic converters. The response of HC and NMHC to fuel sulfur content was non-linear and increased as sulfur level was reduced. In the second set of three fuels, reducing sulfur from 50 to 10 ppm reduced HC and NMHC by 6% and CO by 10%, but had no significant effect on NOx. The effects on HC, NMHC and NOx were not significantly different from predictions based on the prior fuel set. The reduction in CO was larger than predicted.

Effects of methyl tertiary-butyl ether (MTBE) and tertiary-amyl methyl ether (TAME) on emissions were compared in a fleet of ten 1989 model year vehicles. Test fuels containing 11.5 vol.% MTBE or 12.7 vol.% TAME were blended in a base fuel representing federal emission certification fuel. The oxygen content of both fuels was about 2.0 wt.%. No significant differences were found between the two fuels in exhaust mass HC, NMHC, CO, or NOx; in exhaust or evaporative toxic air pollutants, benzene, 1,3-butadiene, acetaldehyde, or total toxic emissions; or in evaporative hot soak emissions. The only differences found to be significant at the 95% level were in mass and estimated reactivity-weighted diurnal evaporative emissions, for both of which the TAME fuel was about 24% lower than the MTBE fuel; and in formaldehyde emissions, which were 28% higher with the TAME fuel.

Emission effects of gasoline hydrocarbon components distilling above 300°F were investigated to determine whether the effect of 90% distillation temperature (T90) found in an earlier Auto/Oil Program study is due to fuel distillation properties or to hydrocarbon composition, and also to determine whether the T90 effect is linear. Twenty-six fuels were tested in two sets. In Matrix A, the independent variables were catalytically cracked (FCC) and reformate stocks with nominal distillation ranges of 300 to 350, 350 to 400 and 400+°F. In Matrix B, the independent variables were a reformate stock (320 to 370°F), a heavy alkylate (330 to 475°F), and a light alkylate distilling below 300°F, which was used to vary fuel T50 at fixed levels of T90. Exhaust mass and speciation were measured using ten 1989 vehicles of the Auto/Oil Current Fleet. Tailpipe hydrocarbon emissions were found to increase nonlinearly with progressive addition of the heavier components.

Engine-out and tailpipe exhaust, and hot soak evaporative emissions of two reformulated test gasolines and an Industry Average reference gasoline were compared in four vehicle fleets designed for progressively lower emission standards. The two reformulated gasolines included: 1) a gasoline meeting 1996 California Phase 2 regulatory requirements, and 2) a gasoline blended to the same specifications but without an oxygenated component. These two gasolines were compared with the Auto-Oil Air Quality Improvement Research Program's (AQIRP) Industry Average gasoline representing 1988 national average composition. The vehicle fleets were the AQIRP Older (1983 to 85MY) and Current (1989MY) vehicle fleets used in prior studies, and two new AQIRP test fleets, one designed to 1994 Federal Tier 1 standards and a prototype Advanced Technology fleet designed for lower emission levels of 1995 and later.

Exhaust emissions of three vehicles fueled with compressed natural gas (CNG) were compared with emissions of three counterpart gasoline vehicles. The natural gas vehicles were tested on four CNG fuels covering a wide range of pipeline natural gas compositions. The gasoline vehicles were tested on AQIRP Industry Average gasoline and a reformulated gasoline meeting California 1996 regulatory requirements. Nonmethane hydrocarbon (NMHC) and toxic air pollutant emissions of the CNG vehicles were about one-tenth those of their counterpart gasoline vehicles, while methane emissions were about ten times those of the gasoline vehicles. Carbon monoxide (CO) and nitrogen oxides (NOx) emissions were more variable among the three vehicle pairs. CO emissions ranged from 20 to 80% lower with CNG than with gasoline, and NOx ranged from 80% lower with CNG to equivalent to gasoline.

Exhaust and evaporative emissions from three flexible/variable fuel vehicles (FFV/VFV) were measured as the vehicles operated on E85 fuel (a mixture of 85% ethanol and 15% gasoline) or on gasoline. One vehicle was a production vehicle designed for ethanol fuels and sold in 1992-93 and the other two vehicles were prototypes which were recalibrated 1992 model year methanol FFV's. The gasolines tested were Industry Average Fuel A and a reformulated gasoline Fuel C2 that met California 1996 regulatory requirements. The gasoline component of Fuel E85 was based on the reformulated gasoline. The major findings from this three-vehicle program were that E85 reduced NOx 49% compared to Fuel A and 37% compared to Fuel C2, but increased total toxics 108% (5 mg/mi) and 255% (20 mg/mi), respectively, primarily by increasing acetaldehyde. The NOx effect was significant for both engine-out and tailpipe emissions.