Search Results

A structured, semi-automatic method for reducing a high-fidelity engine model to a fast running one has been developed. The principle of this method rests on the fact that, under certain assumptions, the computationally expensive components of the simulation can be substituted with simpler ones. Thus, the computation speed increases substantially while the physical representation of the engine is retained to a large extent. The resulting model is not only suitable for fast running simulations, but also usable and updatable in later stages of the development process. The thrust of the method is that the calibration of the fast running components is achieved by use of automatically selected neural networks. Two illustrative examples demonstrate the methodology. The results show that the methodology achieves substantial increase in computation speed and satisfactory accuracy.

The Inflatable Curtain (IC) has shown great potential to reduce head injuries in side impacts. This study explores and presents enhanced performance in two steps of improved activation algorithms. Crash data analysis, 21 full scale crash tests and component tests in a custom built drop tower rig have been performed. The IC performance in wider crash scenarios, including side impacts outside the occupant compartment (L-type impacts), was evaluated. Both statistical crash data and in-depth studies were used. It was found in the analysis of real life crashes that moderate to fatal head injuries can occur without intrusion in the occupant compartment. In L-type side impacts, the motion of the occupant relative to the vehicle interior may cause a head impact of sufficiently high severity to cause moderate to severe head injuries. A combined analysis of real world crash data and crash test results indicates that a substantial reduction in moderate to fatal head injuries can be achieved.

Galvanic corrosion of high purity die cast magnesium alloys AM50 and AZ91 was examined in accelerated atmospheric corrosion testing according to Volvo STD 1027,1375 for 6 weeks involving cycling of the relative humidity between 90% and 45% in combination with intermittent immersion in one of two NaCl-solutions (0.3% or 1.0%). The exposures were performed at two different CO2 levels; 0.01% and 0.3%. The initial general corrosion rate of the AM50 alloy is 50-100% higher than that of AZ91 depending on surface preparation. The corrosion weight loss of both materials depends linearly on salt load in the investigated range. CO2 has a moderate accelerating effect, being higher with decreased salt load. Extreme value analysis was used to evaluate the deepest pit distribution around the perimeter of mounted bolts in panels of AZ91 and AM50. Quite contrary to the general corrosion results, AZ91 showed 30% deeper pits than AM50.

Automotive wind tunnel testing is a key element in the development of the aerodynamics of road vehicles. Continuous advancements are made in order to decrease the differences between actual on-road conditions and wind tunnel test properties and the importance of ground simulation with relative motion of the ground and rotating wheels has been the topic of several studies. This work presents a study on the effect of active ground simulation, using moving ground and rotating wheels, on the aerodynamic coefficients on a passenger car in yawed conditions. Most of the published studies on the effects of ground simulation cover only zero yaw conditions and only a few earlier investigations covering ground simulation during yaw were found in the existing literature and all considered simplified models. To further investigate this, a study on a full size sedan type vehicle of production status was performed in the Volvo Aerodynamic Wind Tunnel.

Under a global impulse for less man-made emissions, the automotive manufacturers search for innovative methods to reduce the fuel consumption and hence the CO2-emissions. Aerodynamics has great potential to aid the emission reduction since aerodynamic drag is an important parameter in the overall driving resistance force. As vehicles are considered bluff bodies, the main drag source is pressure drag, caused by the difference between front and rear pressure. Therefore increasing the base pressure is a key parameter to reduce the aerodynamic drag. From previous research on small-scale and full-scale vehicles, rear-end extensions are known to have a positive effect on the base pressure, enhancing pressure recovery and reducing the wake area. This paper investigates the effect of several parameters of these extensions on the forces, on the surface pressures of an SUV in the Volvo Cars Aerodynamic Wind Tunnel and compares them with numerical results.