Search Results

Edge flanging represents one of the forming modes employed in multistage forming, and advanced high strength steels (AHSS) are more prone to edge cracking during sheared edge flanging than the conventional high strength steels (HSS) and mild steels. The performance of the sheared edge in flanging operation depends on the remaining ductility of the material in the sheared edge after the work hardening (WH) and damage produced by blanking and subsequent forming operations. Therefore, it is important to analyze the effect of work hardening produced by blanking and subsequent forming operations prior to edge flanging on the edge flanging performance. In this study, the effect of different forming operation sequences prior to edge flanging on the edge flanging performance was analyzed for a dual phase 780 steel.

The formability window of a material depends upon the forming limit and its strain distribution ability. For two materials with the same forming limit, the formability performance is governed by their strain distribution ability. In this study, strain hardening behavior of different strength steels was investigated using a uniaxial tension test and the forming limit was studied using both Marciniak cup and dome tests. The n-value of steels varies with strain. Different strain hardening behaviors are found between mild steels and high strength steels. Strain distribution ability of steels increases with the increase in the overall n-value. The peak n-value at a low strain level enhances the strain distribution ability of the steel. It has been shown from both theoretical and experimental studies that a constant thickness strain line exists on the left side of the forming limit curve.

Material constitutive modeling is an important aspect in the continuous improvement process for sheet metal forming simulation and analysis. In this study, a sensitivity study of material constitutive parameters on forming simulation results is carried out for two different sheet metal parts. Three different yield criteria are evaluated in the simulation including isotropic yield criterion, Hill's 1948 anisotropic yield criterion and Barlat's non-quadratic anisotropic yield criterion. It is found that the forming results depend upon the yield criterion used in the simulation. Both thinning and stress in the formed part are very sensitive to the change in anisotropy value (r-value). Effects of strain rate sensitivity of a material on forming results are demostrated through the use of two different stress and strain data from different tensile speeds. It is also found that forming results such as thinning are very sensitive to the strain hardening behavior of the material.

The dent resistance of an automotive body panel has been used as one of key design parameters for automotive body panels. Quasi-static dent testing procedures have been well documented in North America using A/SP Standard Dent Resistance Test Procedures and numerous publications in static denting are also available. However, test procedures under dynamic denting are not very well documented and limited data exist on dynamic denting performance of automotive body panels. In this paper, dynamic dent tests are carried out using different impact velocities and different test procedures. The advantages and disadvantages of test procedures are discussed. Different ways to characterize the dynamic dent test results are investigated and discussed. Due to higher impact velocity during the dynamic dent testing, the acceleration effect must be considered in the data analysis. Experiments were carried out on a hydraulic controlled dynamic dent tester.