Refine Your Search

Topic

Author

Search Results

Standard

Wheel and Brake (Sand and Permanent Mold) Castings - Minimum Requirements for Aircraft Applications

2005-01-05
HISTORICAL
AS586B
This SAE Aerospace Standard (AS) sets forth the minimum quality required for aircraft wheel and brake castings. Its use will establish minimum acceptable requirements for internal structure and surface conditions and is predicated on the use of a casting factor for the ultimate load of more than 1.51 through 2.00. When casting factors of 1.25 through 1.50 are used, visual, penetrant, and radiographic or other approved equivalent nondestructive inspection methods shall all be required on each production casting. Where specific parts, or areas of parts, require a quality level exceeding that described by this document, the requirements shall be established by negotiation between the purchaser and vendor.
Standard

Wheel Chocks

2013-08-13
WIP
J348
This SAE Standard presents the basic information required for the design and manufacture of a wheel chock.
Standard

Wear Test Procedure on Inertia Dynamometer for Brake Friction Materials

2016-11-16
WIP
J2707
This SAE Recommended Practice specifies a dynamometer test procedure to be used for the measurement of automotive service brake linings and disc brake pads wear. Special motor vehicles and motorcycles are excluded from the application. Trailers with nominal Gross Combination Weight Rating exceeding 40 tons are also excluded from this Recommended Practice.
Standard

WIRING COMPONENT DESIGN GUIDELINES

2009-07-10
HISTORICAL
USCAR12-3
This document gives general guidelines to be used during the connector design stage. Various guidelines may not apply in all situations. Therefore, sound engineering judgment must be used in their application. Consider these guidelines as the basis for connector and wiring DFMEA’s. Items in this document are grouped by DFMEA functional requirements. Groups are as follows: A Electrical Continuity B Electrical Isolation/Sealing C Device Assembly D Harness Assembly E Vehicle Assembly F Materials G Serviceability H Environmental Requirements I High Voltage (≥ 60V) Application Requirements
Standard

Verification of Brake Rotor Modal Frequencies

2018-01-10
WIP
J2933
Provide description of standard test methods, analysis methods, and reporting methods for measuring the resonant modes of automotive disc brake rotors and drums for purpose of design and production verification of these components.
Standard

Verification of Brake Rotor Modal Frequencies

2011-03-01
CURRENT
J2933_201103
Provide description of standard test methods, analysis methods, and reporting methods for measuring the resonant modes of automotive disc brake rotors and drums for purpose of design and production verification of these components.
Standard

Vehicular Traffic Sound Signaling Devices (Horns)

2007-12-18
CURRENT
J377_200712
This SAE Standard establishes the minimum operational life, environmental requirements, and sound level output for electrically driven Vehicular Traffic Sound Signalling Devices (hereinafter referred to as Horns) on new automotive vehicles. Test equipment, environment, and procedures are specified.
Standard

Vehicle and Control Modifications for Drivers with Physical Disabilities Terminology

2001-01-29
CURRENT
J2094_200101
The terms included in this SAE Information Report have been collected during the development of SAE documents related to standards for the adaptation of vehicles for use by persons with physical disabilities. It includes only those terms that are pertinent to the adaptive devices discipline, leaving to other authorities more common automotive engineering terms. Where several terms have a common meaning in the practice, the Terminology Task Force has attempted to select the most appropriate term. The Terminology Task Force recognizes that there will be a need to expand and update current terminology as advances in the industry occur, and as related standards documents are completed. Accordingly, they will continue to develop and maintain this document to reflect those changes.
X