Refine Your Search

Search Results

Viewing 1 to 12 of 12
Standard

Air Bleed Objective for Helicopter Turbine Engines

1997-05-01
CURRENT
AIR984C
This SAE Aerospace Information Report (AIR) defines the helicopter bleed air requirements which may be obtained through compressor extraction and is intended as a guide to engine designers.
Standard

Defining and Measuring Factors Affecting Helicopter Turbine Engine Power Available

1998-09-01
CURRENT
ARP1702A
This SAE Aerospace Recommended Practice (ARP) identifies and defines a method of measuring those factors affecting installed power available for helicopter power plants. These factors are installation losses, accessory power extraction, and operation effects. Accurate determination of these factors is vital in the calculation of helicopter performance as described in the flight manual. It is intended that the methods herein prescribe and define each factor as well as an approach to measuring said factor. Only standard installations of turboshaft engines in helicopters are considered. Special arrangements leading to high installation losses, such as the fitting of an infrared suppressor may require individual techniques for the determination and definition of engine installation losses.
Standard

Engine Erosion Protection

1971-02-01
CURRENT
AIR947
This Aerospace Information Report deals with protection of helicopter aircraft engines against erosion. Applicability is restricted to aircraft having a disc loading of less than 15 pounds per square foot.
Standard

Helicopter Engine/Airframe Interface Document and Checklist

1997-06-01
CURRENT
ARP1507A
This SAE Aerospace Recommended Practice (ARP) provides a guide for the preparation of a Helicopter Engine/Airframe Interface Document and Checklist. This document and checklist is intended to provide complete relevant information on the characteristics, performance, and engine interfaces. Of most importance is the identification of the data and the location of data to assure that the engine manufacturer and the airframe manufacturer supply information that can be easily located by either manufacturer.
Standard

Performance of Low Pressure Ratio Ejectors for Engine Nacelle Cooling

1999-03-01
CURRENT
AIR1191A
A general method for the preliminary design of a single, straight-sided, low subsonic ejector is presented. The method is based on the information presented in References 1, 2, 3, and 4, and utilizes analytical and empirical data for the sizing of the ejector mixing duct diameter and flow length. The low subsonic restriction applies because compressibility effects were not included in the development of the basic design equations. The equations are restricted to applications where Mach numbers within the ejector primary or secondary flow paths are equal to or less than 0.3.
Standard

Performance of Low Pressure Ratio Ejectors for Engine Nacelle Cooling

1971-11-01
HISTORICAL
AIR1191
Method: A general method for the preliminary design of a siingle, straight-sided, low subsonic ejector is presented. The method is based on the information presented in References 1, 2, 3, and 4, and utilizes analytical and empirical data for the sizing of the ejector mixing duct diameter and flow length. The low subsonic restriction applies because compressibility effects were not included in the development of the basic design equations. The equations are restricted to applications where Mach numbers within the ejector primary or secondary flow paths are equal to or less than 0.3. Procedure: A recommended step-by-step procedure is shown. Equations: The equations used in the procedure, as well as their derivations, are given. Sample Calculation: A sample calculation is presented to isllustrate the use of the basic method.
X