J2600: Compressed Hydrogen Surface Vehicle Refueling Connection Devices - SAE International
Browse Standards J2600_200210
Historical ISSUED 2002-10-04

Compressed Hydrogen Surface Vehicle Refueling Connection Devices J2600_200210

SAE J2600 applies to design, safety and operation verification of Compressed Hydrogen Surface Vehicle (CHSV) refuelling connection devices hereinafter referred to as nozzle and receptacle. CHSV Refuelling nozzles and receptacles shall consist of the following components, as applicable. Alternatives may be used as long as the alternative geometries shall not be interchangeable with the standard geometry specified in this SAE Standard and the standard geometry in Section 6 provides insufficient flow rates: a. Receptacle and protective cap (mounted on vehicle) (see Section 6 and 7); b. Nozzle (see Section 5).

This document applies to devices which have Working Pressures of 25 MPa, 35 MPa, 50 MPa or 70 MPa hereinafter referred to in this document as the following (see 9.1c): H25 - 25 MPa at 15 °C; H35 - 35 MPa at 15 °C; H50 - 50 MPa at 15 °C; H70 - 70 MPa at 15 °C.

This document applies to nozzles and receptacles which (1) prevent hydrogen fuelled vehicles from being refuelled by dispenser stations with Working Pressures higher than the vehicle; (2) allow hydrogen vehicles to be refuelled by dispenser stations with Working Pressures equal to or lower than the vehicle fuel system Working Pressure, (3) prevent hydrogen fuelled vehicles from being refuelled by other compressed gases dispensing stations and (4) prevent other gaseous fuelled vehicles from being refuelled by hydrogen dispensing stations.

All dimensions used in this document are in metric units [International System of Units (SI)].

For the purposes of this document, compressed hydrogen gas should meet the requirements of ISO 14687 Hydrogen fuel - Product specification.

All references to pressures (MPa) throughout this document are to be considered gauge pressures unless otherwise specified. All test procedures listed in this document are design verification test procedures unless otherwise noted. All products must pass all tests to be considered to have met this design standard.

J2600_201510
2015-10-21
Latest
Revised
J2600_201211
2012-11-19
Historical
Revised
J2600_200210
2002-10-04
Historical
Issued

SAE MOBILUS

Subscribers can view annotate, and download all of SAE's content. Learn More »

Access SAE MOBILUS »

Members save up to 18% off list price.
Login to see discount.
Special Offer: J-Paks offers a customized subscription plan that lets you pay for just the documents that you need, when you need them.

Get Involved

Want to participate in updating this standard?

X